Removing EGR valve on 1.9 tdi
Discussion
I've got a mk4 golf 1.9tdi 150, and have been reading about removing EGR valves, however is there much advantage considering near half my journeys are short ones (around 7miles each way), apparently the car takes longer to warm up with the EGR removed, would it be better to simply clean it out and replace it ?
Has anybody done it on a 1.9 tdi engine and did you notice much difference, ie mpg improvement etc?
Has anybody done it on a 1.9 tdi engine and did you notice much difference, ie mpg improvement etc?
If you're cleaning it out you will want to do the inlet manifold as well, as if one's gunked up then so is the other.
EGR removal always seems to split opinion. Some people swear by it and claim improved MPG and cleaner running etc. The other school of thought is that it can't be cheap to implement it, so why would Audi/VW waste their money on putting it on your car?
Is it possible to blank it off and see how you go? That way you can always reverse it if there is no gain etc.
EGR removal always seems to split opinion. Some people swear by it and claim improved MPG and cleaner running etc. The other school of thought is that it can't be cheap to implement it, so why would Audi/VW waste their money on putting it on your car?
Is it possible to blank it off and see how you go? That way you can always reverse it if there is no gain etc.
Yes , I've thought that the inlet manifold may have to come off too to clean out. It is possible to blank off, but also I've seen people simply remove the vacuum pipe and block that up , that would do the same job wouldn't it, in order to see if there's much difference before committing to it.
Yep. A self tapper screw in the end of the vacuum hose (the bit that normally pushes over the EGR Valve) will stop it from working.
You may throw a check engine light though, when the ECU detects the MAF readings arent as expected. To be honest it makes no difference, and once the EGR is connected again you can turn the engine light off with any basic code reader.
If you do throw an engine light with the egr valve not functioning, and you choose to go for the EGR delete, then you will need the ECU software changing to map out the EGR function, so it no longer causes an error.
You may throw a check engine light though, when the ECU detects the MAF readings arent as expected. To be honest it makes no difference, and once the EGR is connected again you can turn the engine light off with any basic code reader.
If you do throw an engine light with the egr valve not functioning, and you choose to go for the EGR delete, then you will need the ECU software changing to map out the EGR function, so it no longer causes an error.
Gassing Station | Audi, Seat, Skoda & VW | Top of Page | What's New | My Stuff


