Pd 130 1.9t remap reliability ?
Discussion
Got a tdi 130 golf it's on 140k miles is serviced regularly just had cambelt head gasket water pump done starting to want a bit more power is a remap going to change reliability ? Spoken to a few company's that have said it will make no difference but could just be after money any replies much appreciated
The PD engine internals are plenty strong enough to cope with a remap but given the mileage of your car you might want to consider if the turbo is still in good condition and also the state of the pressure pipework and pipe unions betwen the turbo and intercooler and intercooler and inlet manifold as they are known for leaking as the bayonet fittings wear. Might also be worth getting everything cleaned out first - EGR, catalyst, etc and maybe get the codes read to make sure the car is running properly prior to the remap (if code reading is not part of the remapping process).
Cheers for the reply thought no one was going to answer when it got onto the second page had a new boost pipe and inter cooler about 11k miles ago is there anything that would jump out at you as poor turbo health you can hear the turbo working when pushing hard but besides that seems ok and they read the codes on the remap I'm after thanks again for reply
Sounds like it should be ok for a remap then if it's been looked after, egr valve can cause issues so gets deleted a lot of the time but also needs mapping out as well then. Any good tuner should look at the car before doing the map and make sure there are no possible problems that could affect this, mine pd150 leon is going into darkside in just over a week for a exhaust/egr delete and remap as i know they have a great reputation
Good call to get the EGR deleted at the same time.
The EGR valve assembly housing can be replaced with a straight pipe or 'race pipe' (ISTR Allard do one) but this might necessitate new pressure hoses as the standard hoses have metal bayonet end fittings which won't attach to the end of the straight pipe.
A cheaper solution is just to blank off the EGR inlet pipe where it meets the exhaust manifold, then get the engine light turned off as part of the remap. This retains the anti-shudder valve in the EGR housing which has a potentially useful function in shutting down the engine should diesel runaway ever occur. The EGR valve housing is a slight constriction to airflow in the inlet though - not sure how significant this is.
Best to get any others mods you may or may not have been planning done before the remap so it can take advantage of them.
Also watch out for clutch slip if torque is going over around 300lbft (it might not, given you are starting with the 130hp motor), as an uprated clutch can be several times the cost of the remap...
The EGR valve assembly housing can be replaced with a straight pipe or 'race pipe' (ISTR Allard do one) but this might necessitate new pressure hoses as the standard hoses have metal bayonet end fittings which won't attach to the end of the straight pipe.
A cheaper solution is just to blank off the EGR inlet pipe where it meets the exhaust manifold, then get the engine light turned off as part of the remap. This retains the anti-shudder valve in the EGR housing which has a potentially useful function in shutting down the engine should diesel runaway ever occur. The EGR valve housing is a slight constriction to airflow in the inlet though - not sure how significant this is.
Best to get any others mods you may or may not have been planning done before the remap so it can take advantage of them.
Also watch out for clutch slip if torque is going over around 300lbft (it might not, given you are starting with the 130hp motor), as an uprated clutch can be several times the cost of the remap...
Gassing Station | Audi, Seat, Skoda & VW | Top of Page | What's New | My Stuff


