MK1 Seat Leon 20VT misfire or boost issue at high revs
Discussion
Hi all, have a little problem that seems to be getting worse. My 2000 Seat Leon 1.8T is stuttering badly sometimes at high revs, full throttle. Particularly noticeable in higher gears 4000 rpm plus. It doesn't always happen but unfortunately seems to be happening more often now.
If the car wasn't a turbo, I'd call it a misfire but not having much experience with turbos it wouldn't surprise me if it was boost falling away for some reason.
Quite happy to get my hands dirty but thought I'd post here first to see if there is something that is worth checking first.
If the car wasn't a turbo, I'd call it a misfire but not having much experience with turbos it wouldn't surprise me if it was boost falling away for some reason.
Quite happy to get my hands dirty but thought I'd post here first to see if there is something that is worth checking first.
Gad-Westy said:
First thought was coil packs but would that not be apparent at idle?
Not necessarily.. High boost/high RPM needs a strong spark.. That's why I suggested a coil breaking down, rather than out and out failure..
Chuck an OBDII reader at it to see if it's logged any codes..
slinky said:
Not necessarily.. High boost/high RPM needs a strong spark..
That's why I suggested a coil breaking down, rather than out and out failure..
Chuck an OBDII reader at it to see if it's logged any codes..
Great, worth me looking at then. Is an OBII reader going to give me more info than VAGCOM? I have neither but sure I could do something about that. For the record, no warning lights have ever illuminated. That's why I suggested a coil breaking down, rather than out and out failure..
Chuck an OBDII reader at it to see if it's logged any codes..
One other observation that I hadn't forgotten about until the car did it this afternoon is that occassionally it's a little hesitant to start from cold. Turns over for a couple of seconds before catching. Not always, but often enough to not dismiss.
slinky said:
A generic reader should give as much high level detail as VAG Com, but the granular detail would be easier to see with the latter..
Not really, not just for reading fault codes. I got one of these a few years ago - http://www.ebay.co.uk/itm/New-U281-VW-Audi-Skoda-V...Does the job, reads codes from most of the modules on my mk1 Leon Cupra R. You only get the code number so you have to make a note and look them up online but they can be found on the Ross Tech wiki (google for VAGCOM fault codes).
Obvious answer in this case would seem to be coilpack - as above they can show failings only when under load.
Cheers again all. So if I go with a vagcom or OBDII etc, is a coil pack likely to show up? I'd spoken to a mechanic about this some time ago in passing and he thought it was unlikely that the fault would show if no warning light had illuminated. I wasn't so convinced.
I'm happy to spend to sort the issue, I just want to make sure I spend the money wisely as we're not talking about a valuable car here. I've gone down the road of throwing money at cheap parts in the past until one of them corrects the issue but it can be a costly process if you're not right first time.
I'm happy to spend to sort the issue, I just want to make sure I spend the money wisely as we're not talking about a valuable car here. I've gone down the road of throwing money at cheap parts in the past until one of them corrects the issue but it can be a costly process if you're not right first time.
Edited by Gad-Westy on Tuesday 18th March 19:29
Gad-Westy said:
Cheers again all. So if I go with a vagcom or OBDII etc, is a coil pack likely to show up? I'd spoken to a mechanic about this some time ago in passing and I thought it was unlikely that the fault would show if no warning light hat illuminated. I wasn't so convinced.
I'm happy to spend to sort the issue, I just want to make sure I spend the money wisely as we're not talking about a valuable car here. I've gone down the road of throwing money at cheap parts in the past until one of them corrects the issue but it can be a costly process if you're not right first time.
You should see a code for something like "cylinder x: multiple misfires detected" if it is a coilpack that's shot. Some codes won't light the EML immediately, they have to occur so many times within a certain number of drive cycles, miles driven or other criteria.I'm happy to spend to sort the issue, I just want to make sure I spend the money wisely as we're not talking about a valuable car here. I've gone down the road of throwing money at cheap parts in the past until one of them corrects the issue but it can be a costly process if you're not right first time.
One of those code readers will set you back about a tenner delivered, give or take, a new coilpack from SEAT is about £25 IIRC. Don't be tempted to get cheap ones from ECP or similar, they're usually poor quality copies and not likely to last. You may find that once one has gone that the others will follow in due course; I replaced all four of mine with a set of the latest revision ones from Awesome GTI for about £85.
http://www.ebay.co.uk/itm/320915270924?ssPageName=...
This one is slightly more expensive, still less than £30 though. I've recently bought one and it has far more features than I expected. It connects to all the different modules etc and displays codes and information. Can also reset Oil Service and Inspection Service indicators.
(I'm in no way connected to the seller!)
This one is slightly more expensive, still less than £30 though. I've recently bought one and it has far more features than I expected. It connects to all the different modules etc and displays codes and information. Can also reset Oil Service and Inspection Service indicators.
(I'm in no way connected to the seller!)
This is a good option, as it allows you to view live sensor data as well, besides the generic ODBII functionality.
Gendan GCR25 Diagnostic Scan Tool
Gendan GCR25 Diagnostic Scan Tool
Cheers gents. I'll have a read up on those and maybe make a purchase. For the record, I've been out tonight and taken all the plugs out to have a look. They all look fairly healthy or certainly none stood out as an odd one out. I cleaned up all the electrical connectors whilst I was there. Seems my MAF cable is a little loose, it won't click in place. Not sure that is my problem though as it will immediately indicate a warning light if connection is lost and I haven't seen one of those yet.
Gassing Station | Audi, Seat, Skoda & VW | Top of Page | What's New | My Stuff


