R8 launch control doesn't work?
Discussion
On Sunday I had the opportunity to try the launch control on my 2011 R8 V10 at a race track and to my disappointment the damn thing didn't work properly when I needed it; prior to going on to the start line I had tried the procedure several times and it worked fine but as soon as I got the car on to the start line it would not work, I followed the exact procedure every time but nearly every time I got to the start line the engine failed to rev to 5000 RPM leaving me sat there like a dead donkey, it seemed very intermittent indeed. Has any body eles come across this or can offer a reason why this happened?
Not sure if the procedure is the same as an A3 DSG?
If so I find that if you don't depress the footbrake hard enough (to not only hold the car but activate the switch) then it doesn't disengage the clutch/allow the engine to run at 5k but instead tries to drive away with the brakes holding it - it's not the same switch/sensor that activates the brake lights.
If you are holding the brake down firmly enough, maybe the switch is faulty?
If so I find that if you don't depress the footbrake hard enough (to not only hold the car but activate the switch) then it doesn't disengage the clutch/allow the engine to run at 5k but instead tries to drive away with the brakes holding it - it's not the same switch/sensor that activates the brake lights.
If you are holding the brake down firmly enough, maybe the switch is faulty?
catso said:
Not sure if the procedure is the same as an A3 DSG?
If so I find that if you don't depress the footbrake hard enough (to not only hold the car but activate the switch) then it doesn't disengage the clutch/allow the engine to run at 5k but instead tries to drive away with the brakes holding it - it's not the same switch/sensor that activates the brake lights.
If you are holding the brake down firmly enough, maybe the switch is faulty?
that might be the cause, however, when i press the foot brake down and the accelerator pedal it just will not rev up to 5000 RPM, this seems to be the biggest issue, it just wont rev up?If so I find that if you don't depress the footbrake hard enough (to not only hold the car but activate the switch) then it doesn't disengage the clutch/allow the engine to run at 5k but instead tries to drive away with the brakes holding it - it's not the same switch/sensor that activates the brake lights.
If you are holding the brake down firmly enough, maybe the switch is faulty?
Adrian E said:
Sounds like there's a step missing in the process - maybe wrong gearbox mode? In normal use most autos won't allow you to both floor it and hold the brakes on.
Is there a limit on number of uses of launch control like on the M5/6/GTR before it switches off for life?
Apparently there is a limit of 200 launches, which mine cant have done as sometimes it will launch and sometimes it won't, i was wondering if there is a time limit between launches? or does the oil need to be a certain temperature, i have done the correct sequence of switching every time, some time it launches and some times it doesn't?Is there a limit on number of uses of launch control like on the M5/6/GTR before it switches off for life?
The oil temperature needs to be up to temp, of course it does, it is common sense in order to protect the gearbox. There is a bit about it in the user manual or there certainly was in my TTRS. ESP needs to be switched off, firm brake pedal pressure and oil temp at operating temp.
The 200 launches thing is a myth, I launched my TTRS well over that without failure or restriction.
The 200 launches thing is a myth, I launched my TTRS well over that without failure or restriction.
Gassing Station | Audi, Seat, Skoda & VW | Top of Page | What's New | My Stuff


