Is this the start of trouble?
Is this the start of trouble?
Author
Discussion

ryanmcco

Original Poster:

21 posts

154 months

Sunday 13th April 2014
quotequote all
Hi Guys

I've had a 2007 A6 Avant 2.0 140 Auto for a couple of years... has had high mileage but is now pushing the 150k mark. And is starting to show its age..

Until recently I couldn't fault the car, nothing has gone wrong, its had a full audi history and hasn't wanted for anything, but i'm thinking its about to become a money pit.......

Issue 1
We've noticed that under normal acceleration it holds 2000rpm and just increases speed nicely, but at about 50mph it starts to increase revs and appears to get 'stuck' in gear (i know...). If I move the 'shifter' i can see it seems to be stuck in 4th. If Speed up, it will rise to 3500rpm or if I slow down it will change down just fine.

If I use the paddles to force it to 5th it'll continue as normal, deceleration isnt an issue.

I havent taken it into the garage (yet), for reasons below..

Issue 2
We've noticed that when sitting in Drive but at traffic lights the car will shake vigorously going from 900-1100 rpm, a little press of the accelerator will ease it temporarily but its not feeling great... Again Audi hadn't found an issue but suspected the flywheel may need replaced.

Issue 3
Soon approaching a timing chain change.





So, my question, this sounds like the start of money-pit-ness... agree? or am I being a little OTT? Should I just get something newer while it seems fine except for the odd niggle?

thanks

mustdash

360 posts

159 months

Sunday 13th April 2014
quotequote all
I'm not an Audi owner (yet!) but could issue 2 be engine mounts? They went in my old Megane Sport and it was similar to what you describe there. Like I say, not an Audi owner at the minute so may be wide of the mark but just a thought.

ryanmcco

Original Poster:

21 posts

154 months

Sunday 13th April 2014
quotequote all
Hi Mustdash,

yeah i think you could be right...

wonder how much that is to fix?

Rich_W

12,548 posts

243 months

Sunday 13th April 2014
quotequote all
Number 1. AS you know it's a CVT so it's meant to do the holding revs thing. But not sure on the other bit. Pay the labour somewhere to get a computer plugged in to it.

Number 2 is almost certainly the dual mass flywheel.

Number 3. Not a chain, but a belt. As ever consider the water pump at the same time (no extra labour just part cost)

ryanmcco

Original Poster:

21 posts

154 months

Sunday 13th April 2014
quotequote all
Cheers Rich, for 2 & 3 together we're probably looking at a tidy sum... I hear terrible things about the CVT when it goes wrong... Starting to think this car is going to be more trouble than its worth ;(