A6 2.7T Quattro Avant - borked by the passenger side leaks
Discussion
So, thought I'd got away with just a fubar'd alarm and installing a kill switch so no more parked up alarm issues, however it's now extended to the indicators flashing on, off, work, not work, interior lights flashing on and off etc. Mrs said no confidence cars got to go. So bought a 325i this morning to replace the barge, anyway it's a bit gutting as in the last 4 months I've give the A6 a new alternator, rear discs, pads, 4 new tyres and a rear calliper. Mechanically the car is fine, engine, turbos perfect, last MoT it had some new gators fitted and no other advisories. Box is a bit clunky if you lift off then get quickly on the gas again. Body's 'used' front arch rust and rear a little too. Still, I would have aimed for at least 2 more years out of it, it's a 2000 with 127,000 mile on it.
So question is:-
A) eBay buy a new comfort ecu, hope for the best and it all works again. - keep for winter when the BMW will be s
t.
B) stick it on eBay as described above.
C) buy comfort ecu and then stick it on eBay as fine, but otherwise as above.
D) break it for parts, I have the space, has full factory tow bar, heated leather etc etc
Ironically this morning when I moved it to the back of the drive it all worked perfectly showing no electrical gremlins at all.
What do people think, shame to kill off such a car that for all intent purposes of being a car, ignoring indicator issues is great?
So question is:-
A) eBay buy a new comfort ecu, hope for the best and it all works again. - keep for winter when the BMW will be s
t.B) stick it on eBay as described above.
C) buy comfort ecu and then stick it on eBay as fine, but otherwise as above.
D) break it for parts, I have the space, has full factory tow bar, heated leather etc etc
Ironically this morning when I moved it to the back of the drive it all worked perfectly showing no electrical gremlins at all.
What do people think, shame to kill off such a car that for all intent purposes of being a car, ignoring indicator issues is great?
Edited by Herman Toothrot on Monday 26th May 13:43
I used to have simualr Symptons with my old bora, turned out to be a fault with the hazard switch of the indicator stalk modual thing, changed both and the problem went.
Could be worth a shot? Have you had someone with VAG COM scan the car for codes too? MIght be simple
If not IDE stick it on eBay with the problems listed
Could be worth a shot? Have you had someone with VAG COM scan the car for codes too? MIght be simple
If not IDE stick it on eBay with the problems listed
Have you actually lifted the front passenger side carpet (requires removal of the A pillar lower trim and the plastic moulding on the lower edge of the door aperture) to check if water is swimming about? If it's been leaking it WILL have litres of the stuff under there as the sound deadening is extremely dense and a great sponge!
It isn't necessarily plenum drains either - in ours it was the air conditioning system. It has a small funnel shaped plastic housing that empties via a bung under said carpet to under the car. Even though it can appear to be draining fine it took partial removal of the funnel and 'rodding' with a brush I have for cleaning my camelback to remove whatever debris was stopping it working properly. If you have access to ramps you might be able to get to it through the bung but it's part way up the firewall and not easy to spot. If it's not running out consistently with the air-con running, or it's dribbling out, then that's defo a place to start. When it's working properly you should get a consistent wet patch under the passenger side of the car which will be a regular drip-drip-drip.
Another indicator of problems is to remove any mats from the rear passenger side and stick your hand down near the air vent under the front seat - if it's damp/wet then it's VERY wet underneath.
Once you have access it is VERY easy to remove the entire 'convenience module' plastic box - once opened I'd expect it to have significant amounts of water inside and possibly corrosion evident on the pins. The actual circuit board can be completely removed from its box very easily so you can check for blown components.
I bought some WD40 branded contact cleaner, which also disperses water, from Maplin. Gave it a good coating and left it to dry out completely with the carpet pulled back for at least a week in hot summer, also ran a dehumidifier in the car.
BBA reman will refurb it if it's fried but I'd try the drying out option first.
We had the indicators on all the time, alarm/central locking u/s, doors unlocking themselves etc symptoms ,and after the above it has been entirely fault free for nearly a year now.
I'd at least try and fix it for relatively little money - you may well fix it completely or at least deal with the original cause. If I was looking at a cheap A6 exhibiting symptoms like yours I wouldn't touch it with a barge pole for fear of an enormous dealer derived bill to replace lots of componentry without dealing with the root cause. There's enough horror stories dating back to late 90s Passats onwards that most people know it's a common fault.
It isn't necessarily plenum drains either - in ours it was the air conditioning system. It has a small funnel shaped plastic housing that empties via a bung under said carpet to under the car. Even though it can appear to be draining fine it took partial removal of the funnel and 'rodding' with a brush I have for cleaning my camelback to remove whatever debris was stopping it working properly. If you have access to ramps you might be able to get to it through the bung but it's part way up the firewall and not easy to spot. If it's not running out consistently with the air-con running, or it's dribbling out, then that's defo a place to start. When it's working properly you should get a consistent wet patch under the passenger side of the car which will be a regular drip-drip-drip.
Another indicator of problems is to remove any mats from the rear passenger side and stick your hand down near the air vent under the front seat - if it's damp/wet then it's VERY wet underneath.
Once you have access it is VERY easy to remove the entire 'convenience module' plastic box - once opened I'd expect it to have significant amounts of water inside and possibly corrosion evident on the pins. The actual circuit board can be completely removed from its box very easily so you can check for blown components.
I bought some WD40 branded contact cleaner, which also disperses water, from Maplin. Gave it a good coating and left it to dry out completely with the carpet pulled back for at least a week in hot summer, also ran a dehumidifier in the car.
BBA reman will refurb it if it's fried but I'd try the drying out option first.
We had the indicators on all the time, alarm/central locking u/s, doors unlocking themselves etc symptoms ,and after the above it has been entirely fault free for nearly a year now.
I'd at least try and fix it for relatively little money - you may well fix it completely or at least deal with the original cause. If I was looking at a cheap A6 exhibiting symptoms like yours I wouldn't touch it with a barge pole for fear of an enormous dealer derived bill to replace lots of componentry without dealing with the root cause. There's enough horror stories dating back to late 90s Passats onwards that most people know it's a common fault.
Gassing Station | Audi, Seat, Skoda & VW | Top of Page | What's New | My Stuff



