reverse light failure on 2008 Audi A6 avant
reverse light failure on 2008 Audi A6 avant
Author
Discussion

morebeanz

Original Poster:

3,283 posts

267 months

Monday 23rd June 2014
quotequote all
I'm trying to trace a fault on my Audi A6 avant.

I had the lamp warning light on the dash come on, and so duly replaced the bulb (brand new) on the driver's side reversing light. However the light still does not work, so I am looking for other approaches. I'm no electrical genius, but I figured there must be some other simple checks I can make before giving up!

All the other lights work fine, including the passenger side reversing light.

Any thoughts?

Thanks!

Maracus

4,553 posts

199 months

Monday 23rd June 2014
quotequote all
I had the same issue recently, with the same bulb.

The problem was with the earth pin on the plug from the car's wiring loom that goes in the rear inner light cluster. It'll need cleaning off with a small flat blade screwdriver and maybe some contact fluid. It took quite a few attempts to clean it up on mine. The pin looks clean on the face of it. It's one of the outer pins.

blueg33

46,943 posts

255 months

Monday 23rd June 2014
quotequote all
Maracus said:
I had the same issue recently, with the same bulb.

The problem was with the earth pin on the plug from the car's wiring loom that goes in the rear inner light cluster. It'll need cleaning off with a small flat blade screwdriver and maybe some contact fluid. It took quite a few attempts to clean it up on mine. The pin looks clean on the face of it. It's one of the outer pins.
This - appears to be an A6 design fault. My saloon did it with rear lights. Fixed with contact cleaner and a little emery paper

Dr G

16,006 posts

273 months

Tuesday 24th June 2014
quotequote all
Yup, the PCB/contacts corrode slightly.

gregpot2000

314 posts

175 months

Tuesday 24th June 2014
quotequote all
Had same on my 2008 A4. New bulb holder sorted it, it was only about £20 so was happy about that.