All brakes stuck on seat Leon cupra

[Old man dave]

Hi could anybody help I have got a seat Leon Cupra that has all breaks sticking on , I have changed both callipers and the master cylinder as they were leaking , brakes have been bled..any advice please

[DuraAce]

All brakes stuck on? As in properly stuck fully on? Or just dragging a bit? (I love a nice descriptive thread fully explaining the issue!!)
Yet you've replaced both (2?) calipers? Why have you replaced them?

Issue with the brake booster /pedal assembly or a fault in the abs unit causing pressure to remain in the lines would be my guess?

Abs interrogated for fault codes?

[Old man dave]

Yeah both rear callipers were leaking and so was master cylinder , was told that there is adjustment you can do to the rod in the servo but not sure

[DuraAce]

Take it to a garage then.

I asked if you've interrogated the abs system for faults? (control unit fault codes, read what the line pressures are etc).
I asked if they were fully stuck on, or just dragging, all the brakes? Or just the rears? It's very hard to help when you don't give us any feedback at all.

I'm out, as they say.

[Old man dave]

Sorry all brakes stuck on and fault finder gave up no codes

[Old man dave]

Sorry all brakes stuck on and fault finder gave up no codes

[Vanordinaire]

Presuming they were OK when you put the new calipers on? So it's something that happened after that? Immediately after? Or while you bled them? Or after you'd been driving for a bit?
No one can give you any advice on this unless you go into a bit more detail.

[Oscar011]

Need to confirm? Were the brakes stuck on before you changed the Calipers and master cylinder or after?