Feeder pipe location for rear washer on S3
Discussion
Hi
Can someone please help me by telling me whereabouts under the bonnet I can locate the feeder pipe for the rear washer on my 1999 S3
The washer has stopped working and when the car was serviced last year the garage re-fitted the pipe, so I suspect it has come loose again
Many thanks
Can someone please help me by telling me whereabouts under the bonnet I can locate the feeder pipe for the rear washer on my 1999 S3

The washer has stopped working and when the car was serviced last year the garage re-fitted the pipe, so I suspect it has come loose again
Many thanks
They usually come apart inside the boot. I'd check the connections to the wiper motor first.
You are sure its not just a blocked jet? Does it sqirt out the midle of the wiper when you take the jet out?
Should it turn out to be at the pump end, you need to take the N/S wheel arch liner out to get to it.
You are sure its not just a blocked jet? Does it sqirt out the midle of the wiper when you take the jet out?
Should it turn out to be at the pump end, you need to take the N/S wheel arch liner out to get to it.
Tame Technician
Many thanks for your reply, I have just tested the washer with the car static on the roadside and a getting water coming out on the nearside of the engine bay towards the bulkhead.
Unfortunately I cannot really see exactly where the water is coming from.
Any suggestions?
Many thanks for your reply, I have just tested the washer with the car static on the roadside and a getting water coming out on the nearside of the engine bay towards the bulkhead.
Unfortunately I cannot really see exactly where the water is coming from.
Any suggestions?
Thats the pump end then, the pump is attached to washer fluid botle, is most likely that its blown the pipe off, they do that, but somtimes a bit breaks off the pump and a new pump is needed.
To gain access to refit the pipe or check if its a broken pump, you need to remove the N/S/F ( front passenger side) wheel arch liner, the big black piece of plastic thats inside the wing (you will need the wheel off for this)
Normally they blow the pipe off because the washer jet is blocked, (build up of pressure) did you try the rear washers with the rear jet removed??
To gain access to refit the pipe or check if its a broken pump, you need to remove the N/S/F ( front passenger side) wheel arch liner, the big black piece of plastic thats inside the wing (you will need the wheel off for this)
Normally they blow the pipe off because the washer jet is blocked, (build up of pressure) did you try the rear washers with the rear jet removed??
Dont take the wheel arch liner off. And no dont bother taking the rear jet off, if its coming out in the engine bay its not going to work.
Your best off removing the air box, then have someone operate the jet and you will see where the waters coming from. If you look next to the NSF shocker top mounting point the plastic cowelling is next to it.
Your best off removing the air box, then have someone operate the jet and you will see where the waters coming from. If you look next to the NSF shocker top mounting point the plastic cowelling is next to it.
Gassing Station | Audi, Seat, Skoda & VW | Top of Page | What's New | My Stuff


