A3 8P 3.2 Fault Code - TAME TECHNICIAN
Discussion
Engine management light came on in my A3 on friday night, got it on the diagnostics at work yesterday and came back with a fault code but we're a tad confused by what it means!!
"Mixture correction (bank 2) lean: P2098"
assuming it is lambda sensor related judging by mixture correction.
Any help would be greatly appreciated!
"Mixture correction (bank 2) lean: P2098"
assuming it is lambda sensor related judging by mixture correction.
Any help would be greatly appreciated!
Bank 2 Means cylinders 4 5 6, the three nearest the gearbox end of the engine.
Could be any of the usual causes of running lean, air leak from vac or breather pipe etc,
Or it could just be the lambda probe misreading.
Check the live data for lambda output and short term fuel trim, see what they are doing with the engine at idle, Fuel trim +% means its lean -% means its rich. Should be between -5% and + 5%. To log that fault would have to be over +20% on that bank.
Look at teh fuel trims see what they are doing and then spray a load of brake cleaner arround the inlet manifold and all vacuum connections, if the fuel trim suddenly drops, say from +20% to like -20% when you spray, you have found you air leak.
Check the connections at the lambda probes they can get full of water and corroide. If you suspect a probe you could swap it with the one from bank one, if the fault still occurs for bank two, you know its not the sensor, if the fault moves to bank one with the sensor swap, then its the sensor misreading.
Could be any of the usual causes of running lean, air leak from vac or breather pipe etc,
Or it could just be the lambda probe misreading.
Check the live data for lambda output and short term fuel trim, see what they are doing with the engine at idle, Fuel trim +% means its lean -% means its rich. Should be between -5% and + 5%. To log that fault would have to be over +20% on that bank.
Look at teh fuel trims see what they are doing and then spray a load of brake cleaner arround the inlet manifold and all vacuum connections, if the fuel trim suddenly drops, say from +20% to like -20% when you spray, you have found you air leak.
Check the connections at the lambda probes they can get full of water and corroide. If you suspect a probe you could swap it with the one from bank one, if the fault still occurs for bank two, you know its not the sensor, if the fault moves to bank one with the sensor swap, then its the sensor misreading.
Thanks for that will have a play with the diagnostics when I get a chance.
But the situation has magnified, slight blow on the exhaust turns out to be both flexies are utterly shagged! Looking at it, the bottom engine mount has alot of movement, but doesn't look split, is this a common thing?or are they meant to move a lot? Would make sense ifthe engine mount has gone and that has killed the flexes!
But the situation has magnified, slight blow on the exhaust turns out to be both flexies are utterly shagged! Looking at it, the bottom engine mount has alot of movement, but doesn't look split, is this a common thing?or are they meant to move a lot? Would make sense ifthe engine mount has gone and that has killed the flexes!
Gassing Station | Audi, Seat, Skoda & VW | Top of Page | What's New | My Stuff


