VW Touran - Seal around the cylinder head?
Discussion
Long story - but my 2004 2.0tdi Touran started using coolant a year or so ago. Pistonheads initially suggested it was the EGR valve, but this was ruled out and a new cylinder head was needed due to the original one going porous.
VW offered to pay for 50% of the repair bill but i still had to find £1500. Yes i used the main dealer in Swindon.
A few weeks after the repair, one of the pipes connecting the turbo to the exhaust fell off and the car made loads of noise and had no power. The garage admitted this was their mistake and repaired.
Since we have the car back it no longer uses coolant, but pisses oil all over my driveway.
I have taken it back on several occasions and last time they replaced a oil pipe somewhere and sent a man to clean the oil from my driveway.
Yesterday i noticed that the drive was again covered in oil, i took the car to the main dealer again. The promised a call by lunchtime and as always - nothing. I called them at 16:00 and they told me that the main seal around the cylinder head was leaking. They need a new part and this will be available tomorrow. Car will be available to collect on Thursday.
So my question is;
Is this possible and if it is, does it mean that the cylinder head was not repair correctly last time?
Would any damage have been done to the cars engine due to this?
What can i do - I have lost all faith in the car and main dealer now....
VW offered to pay for 50% of the repair bill but i still had to find £1500. Yes i used the main dealer in Swindon.
A few weeks after the repair, one of the pipes connecting the turbo to the exhaust fell off and the car made loads of noise and had no power. The garage admitted this was their mistake and repaired.
Since we have the car back it no longer uses coolant, but pisses oil all over my driveway.
I have taken it back on several occasions and last time they replaced a oil pipe somewhere and sent a man to clean the oil from my driveway.
Yesterday i noticed that the drive was again covered in oil, i took the car to the main dealer again. The promised a call by lunchtime and as always - nothing. I called them at 16:00 and they told me that the main seal around the cylinder head was leaking. They need a new part and this will be available tomorrow. Car will be available to collect on Thursday.
So my question is;
Is this possible and if it is, does it mean that the cylinder head was not repair correctly last time?
Would any damage have been done to the cars engine due to this?
What can i do - I have lost all faith in the car and main dealer now....
The main dealer called me up today. Car is no longer leaking.
Apparently, the car doesnt use a gasket as such (what does that mean?) but some sealant that goes between the cylinder head and the block.
This was ill applied when the head was originally replaced.
Car is no longer leaking, although they suggest bringing it back in two weeks for a check over.
Problem is that i plan to make a 800 mile trip to Europe over the next two weeks.
GROAN.
Apparently, the car doesnt use a gasket as such (what does that mean?) but some sealant that goes between the cylinder head and the block.
This was ill applied when the head was originally replaced.
Car is no longer leaking, although they suggest bringing it back in two weeks for a check over.
Problem is that i plan to make a 800 mile trip to Europe over the next two weeks.
GROAN.
Picked the car up today. It has a full tank of fuel and has been valeted as an apology for the cylinder head work.
All the reception staff were on lunch break at 16:00, except for a young trainee.
I told her that we were planning a road trip and she told me "Well oil leaking from the car isn't a major problem" - WTF - do you even know what a car is?
VW Swindon - Inchcape - Useless.
All the reception staff were on lunch break at 16:00, except for a young trainee.
I told her that we were planning a road trip and she told me "Well oil leaking from the car isn't a major problem" - WTF - do you even know what a car is?
VW Swindon - Inchcape - Useless.
Edited by Ray Singh on Thursday 19th August 16:28
Ray Singh said:
The main dealer called me up today. Car is no longer leaking.
Apparently, the car doesnt use a gasket as such (what does that mean?) but some sealant that goes between the cylinder head and the block.
Errr thats a complete lie if i have ever heard one - They use a multi layer steel head gasket - and there is a rubber cam cover gasket also..Apparently, the car doesnt use a gasket as such (what does that mean?) but some sealant that goes between the cylinder head and the block.
They must be talking about the ladder on the top of the cylinderhead, that holds the cams in.
This is sealed with black silicon based sealant, rather than a gasket. I've had to reseal a couple on heads that have been replaced.
Causes oil to leak from arround the camshaft area, top end of the engine but under the cam cover gasket level.
Its the age old problem of the technician saying what he has found and done to fix it, and the service advisor passing on a completely different message to the customer.
My personal favorite was when a free wheel pulley turned into a flywheel, that had the customer confused.
This is sealed with black silicon based sealant, rather than a gasket. I've had to reseal a couple on heads that have been replaced.
Causes oil to leak from arround the camshaft area, top end of the engine but under the cam cover gasket level.
Its the age old problem of the technician saying what he has found and done to fix it, and the service advisor passing on a completely different message to the customer.
My personal favorite was when a free wheel pulley turned into a flywheel, that had the customer confused.
Gassing Station | Audi, Seat, Skoda & VW | Top of Page | What's New | My Stuff


