VW "Climatic" heater/aircon temperature problem
VW "Climatic" heater/aircon temperature problem
Author
Discussion

Toilet Duck

Original Poster:

1,367 posts

216 months

Tuesday 14th September 2010
quotequote all
Evening all,

My 56 plate VW Polo Sport 1.9 Tdi (100BHP) has developed an annoying problem with the heating/air con system. it uses the VW "Climatic" system, which is probably used in other VAG cars. If I have the temperature dial set to cold, then cold air from the outside comes in. If I press the aircon button, then the compressor kicks in and the cold air turns icy and all works as it should. However, as soon as I adjust the temperature dial by just one or two clicks, it has the effect of turning the temperature up to max i.e. within a few minutes the air entering the cabin is as hot as if I'd turned the temperature dial all the way round to its highest temperature setting. The same happens regardless of whether the aircon button is pressed or not, and regardless of what fan speed I set the dial to. So basically, I can either have cold air (same temp as outside air) coming into the cabin, ice cold aircon air entering the cabin, or full on sweat-your-nutsack-off maximum heat setting air entering the cabin. This has been doing it for some time. During the summer its not been a problem as I've always got the temp set to min. However, now the weathers changing I can't have a bit of warmth in the cooler mornings; its either cold or boiling hot air.

I've been searching the net and found the following on the VW website (http://www.volkswagen.com/vwcms/master_public/virtualmaster/en2/experience/innovation/technical_glossary/climatic.popup.html):

Climatic from Volkswagen is a semi-automatic air conditioning system which automatically regulates the temperature of the fresh air supply depending on the desired temperature setting. Air distribution and blower speed are set manually by the driver. Climatic includes an interior sensor to measure the current temperature inside the car. The electronic control regulates the temperature of the fresh air intake to reach the set value as quickly as possible and then maintain it constantly.

Im wondering if the "interior sensor" mentioned in the above has gone faulty? I've tried googling, but cannot find where this sensor is located. Does anyone know? Is it possible to buy/replace just the sensor, or is it (as I fear) integrated into the entire heating/ventilation control panel?

If anyone can help or point me in the right direction then I would be very greatful. I don't really want to take it into a dealer if I don't have to, as Im already getting my pants pulled down to the tune of £400 for a cambelt/waterpump change in the next few weeks frown

Many thanks in advance! smile


Toilet Duck

Original Poster:

1,367 posts

216 months

Wednesday 15th September 2010
quotequote all
Anyone? frown

Matt-b

73 posts

238 months

Wednesday 15th September 2010
quotequote all
You ideally need the A/C control unit fault memory checked - It is pretty common for the motor that controls the temperature to fail and just do as it pleases

Toilet Duck

Original Poster:

1,367 posts

216 months

Thursday 16th September 2010
quotequote all
Matt-b said:
You ideally need the A/C control unit fault memory checked - It is pretty common for the motor that controls the temperature to fail and just do as it pleases
Cheers for the reply. Where is the motor that you refer to located? If it is this that has failed, can it be purchased/fitted seperately or is it part of a larger component? To get the A/C fault codes, are these accesed via the dealer computer (is it VAG-COM or something?) or can I read them off myself somehow (by pressing/holding button etc?).

Thanks again for your help!