Main dealer RANT. (ish)
Discussion
Hi folks.
I've just spent best part of this afternoon/evening working on my car. A fault developed with a sensor, coolant temp, causing the car to eat derv like it was going out of fashion (ecu thinks it's cold all the time runs very rich) and also a temp needle that goes up and down at random, VERY distracting when your driving.
So to cut a long story short, the assholes supplied the WRONG sensor, even after, having looked at the proffered new one in the dealers and pointing out it had 4 pins and the one (still) fitted to the car was twin wired, they insisted that this was correct and OK.
WRONG
So I have a very busy afternoon lined up tomorrow. So I have to get to Dundee, in the morning, "discuss" the situation with, hopefully, an adult to find a resolution (and NOT lose the heid).
Then get back home "somehow", fit sensor, rebuild airbox/filter piping and more sensors, re-establish and leak check coolant system and oil filter housing THEN get to Perth for 17:55 to sign on.
I would have had this done tonight but for the wrong sensor issue.
I'm a bit pissed off.
Mo.
I've just spent best part of this afternoon/evening working on my car. A fault developed with a sensor, coolant temp, causing the car to eat derv like it was going out of fashion (ecu thinks it's cold all the time runs very rich) and also a temp needle that goes up and down at random, VERY distracting when your driving.
So to cut a long story short, the assholes supplied the WRONG sensor, even after, having looked at the proffered new one in the dealers and pointing out it had 4 pins and the one (still) fitted to the car was twin wired, they insisted that this was correct and OK.
WRONG
So I have a very busy afternoon lined up tomorrow. So I have to get to Dundee, in the morning, "discuss" the situation with, hopefully, an adult to find a resolution (and NOT lose the heid).
Then get back home "somehow", fit sensor, rebuild airbox/filter piping and more sensors, re-establish and leak check coolant system and oil filter housing THEN get to Perth for 17:55 to sign on.
I would have had this done tonight but for the wrong sensor issue.
I'm a bit pissed off.
Mo.
So am I correct in reading taht the dealer only supplied the part?
They would usually look it up on the chassis number, assuming that it was provided. Very occasionaly these are wrong, particularly when a model gets a small update/revision or there's a recall etc. Unusual that nothing was said when you commented on the connector being the wrong one, strange also that you accepted the part if you knew that it wouldn't fit...
They would usually look it up on the chassis number, assuming that it was provided. Very occasionaly these are wrong, particularly when a model gets a small update/revision or there's a recall etc. Unusual that nothing was said when you commented on the connector being the wrong one, strange also that you accepted the part if you knew that it wouldn't fit...
Dr G said:
So am I correct in reading taht the dealer only supplied the part?
They would usually look it up on the chassis number, assuming that it was provided. Very occasionaly these are wrong, particularly when a model gets a small update/revision or there's a recall etc. Unusual that nothing was said when you commented on the connector being the wrong one, strange also that you accepted the part if you knew that it wouldn't fit...
I didn't say ANY of that They would usually look it up on the chassis number, assuming that it was provided. Very occasionaly these are wrong, particularly when a model gets a small update/revision or there's a recall etc. Unusual that nothing was said when you commented on the connector being the wrong one, strange also that you accepted the part if you knew that it wouldn't fit...

Gassing Station | Audi, Seat, Skoda & VW | Top of Page | What's New | My Stuff


