Tame tech advice needed Please!!
Tame tech advice needed Please!!
Author
Discussion

iash101

Original Poster:

46 posts

194 months

Tuesday 12th October 2010
quotequote all
Hi tt I need ur advise once again.

Im fitting a new abs pump to my seat leon fr tdi 170 on the weekend and i need a bit of advice about the brake setup and bleeding procedure.
Iv got vag com and a presure bleeder but im not sure what the step by step procedure is.

could you give me some advise on how to blead the brakes.

Cheers Tt

944fan

4,962 posts

216 months

AJB

856 posts

246 months

Wednesday 13th October 2010
quotequote all
Don't know if this is any use:

http://www.ross-tech.com/vag-com/cars/absbleeding....

Pretty sure Haynes isn't when it comes to VAG COM type stuff.

I think the idea is to do that procedure whilst pressure bleeding the system, so the fluid flowing through picks up the air bubbles coming out of the ABS unit due to running its pump. I might be very wrong about that though...

Edited by AJB on Wednesday 13th October 13:14

Tame Technician

2,467 posts

235 months

Friday 15th October 2010
quotequote all
First things first.

You only need to runs the ABS pump and bleed if somthing goes wrong and you still dont have a pedal after lots of bleeding the normal way.

You will need lots of brake fluid. 2 litres maybe.

-This is what I do and its always worked for me.-


(1) Replaced the abs module assemble.

(2) Refill reservior with fluid, unless you were very quick it will be empty.

(3) If it has one, probbably wont, but if it has, crack open the bleed nipple/nipples on the end of the master cylinder. Let gravity push out the air and close once fluid is comming out. If it hasnt got bleed nipples, crack off the pipe from the master cylinder, one at a time, and let the air come out of there.

(4) On the ABS module, note the two bigger bore brake pipes from the master cylinder to the abs module, crack these undone a few turns and let the air be pushed out by gravity once you see fluid retighten.

(5) normal brake bleed procedure at the calipers, either up down up down for hours, or pressure bleed (set to 2bar/28psi)
(you will probably need the rear wheels off, unless you have 18inch+ wheels, not alot of room)

ELSA says start at N/S/F then O/S/F, then N/S/R then O/S/R. I do this.

but many people do N/S/R - O/S/R - N/S/F - O/S/F

Then check you have a pedal, if its really crap then you may need to the the ABS pump thing as per the link but i never have.

iash101

Original Poster:

46 posts

194 months

Friday 15th October 2010
quotequote all
Thanks everyone!!
Thanks Tt for the indepth proceure!!