Dipped beam adjustment on RS6
Discussion
My dipped beam is too high, to the extent that I get flashed quite a lot. In fact, the main beam is also too high.
I see from the manual that the beams automatically adjust themselves to compensate for load balance. However, I cannot find out if I can manually change the beam height.
Does anybody know if it is possible to do this myself (without taking it to the garage)?
Don
--
I see from the manual that the beams automatically adjust themselves to compensate for load balance. However, I cannot find out if I can manually change the beam height.
Does anybody know if it is possible to do this myself (without taking it to the garage)?
Don
--
If you know someone one with VAG -COM you can try following this procedure:
[Select]
[55 - Xenon Range]
[Basic Settings - 04]
Group 001
[Go!]
Activate the Basic Setting.
[ON/OFF/Next]
The meas. block field now shows "Wait" and should switch to "Adjust Headlights" then (this may take up to 10 seconds).
Adjust the headlights using their manual adjusting screws as referenced against a suitable aiming target.
[ON/OFF/Next]
The adjustment should now be learned.
[Done, Go Back]
Don't forget to check/clear fault codes afterwards.
[Close Controller, Go Back - 06]
Did this on a 07 S3 and worked fine - hope this helps
[Select]
[55 - Xenon Range]
[Basic Settings - 04]
Group 001
[Go!]
Activate the Basic Setting.
[ON/OFF/Next]
The meas. block field now shows "Wait" and should switch to "Adjust Headlights" then (this may take up to 10 seconds).
Adjust the headlights using their manual adjusting screws as referenced against a suitable aiming target.
[ON/OFF/Next]
The adjustment should now be learned.
[Done, Go Back]
Don't forget to check/clear fault codes afterwards.
[Close Controller, Go Back - 06]
Did this on a 07 S3 and worked fine - hope this helps
If they are the same as my S6, there is a manual adjustment.
You need a very long screwdriver as you dont have a lot of room to work. Mine were set stupidly low by the dealer at the first MOT. I moaned, they refused to accept they had done anything so I took it to another dealer....we put it on the light pod things for MOT's and manually adjusted them up. Simple.
You need a very long screwdriver as you dont have a lot of room to work. Mine were set stupidly low by the dealer at the first MOT. I moaned, they refused to accept they had done anything so I took it to another dealer....we put it on the light pod things for MOT's and manually adjusted them up. Simple.
Gassing Station | Audi, Seat, Skoda & VW | Top of Page | What's New | My Stuff




