1.8t starting problems
Author
Discussion

powwerr

Original Poster:

1,978 posts

203 months

Sunday 23rd January 2011
quotequote all
Hi there, hoping to see if someone can shed some light on my problem.

its a bora 1.8t AUM. over the winter the car struggled a little bit to start in the really cold mornings, occasionally throwing up a "STOP check engine coolant" msg, once turned off and back on this would go away.

Now, when i go to start the car it really stuggles to crank. I put a brand new decent spec battery in last week, still the same.

turn the key- turns over very slow(as if battery is low)- keep key turned and it slowly gathers momentum to crank and fire. About 5secs to start.

Alternator only charging a little? Starter motor? ???

Any info greatly appreciated. Thanks.

OctyVrs

107 posts

191 months

Monday 24th January 2011
quotequote all
Possibly poor connection or starter motor on its way out. I'd be inclined to say bad earth given the intermittent wrong error for coolant.

If you remove the negative battery lead (10mm nut), give the battery post and the inside of the clamp a decent rub with emery cloth. Leave that disconnected and remove the positive clamp and do the same. With them both off, lift out the battery (just for easier access, you might have smaller hands than me and not need to). Can't remember the side of the wee bolt that clamps the battery, is it a 13mm?

Remove the battery tray for easier access too (4x wee 10mm bolts, there's a torx screw into the airbox too, can't remember what size though). Follow the positive battery lead down to the starter motor, use a flat bladed screwdriver and prise the wee plastic cap off the starter motor post. Remove the nut that clamps the battery lead to the starter post, 13mm.

Emery cloth to clean back to bare metal on both the battery lead end and the face of starter motor post - it's slightly awkward because of the threaded post sticking out the middle but will only take a couple of mins.

On the back firewall side of the starter motor, if you feel down past the solenoid, there's a wee braided wire runs down to the starter body. These corrode if not protected. Check the condition of it. If you can destroy it with a light poke of the screwdriver, then that's the problem.

Assuming that's good, trace the negative battery lead to the engine block, unbolt (13mm) and clean the terminal and the earth strap with emery cloth.

Reassemble it all, just before you put the battery back in, use a multi meter to test resistance from the negative lead to - the engine block, the gearbox, the starter motor, and a bare bit of metal on the bodyshell, they should all read the same, will be very low resistance.

powwerr

Original Poster:

1,978 posts

203 months

Monday 24th January 2011
quotequote all
Thanks very much! will do and report back. cheers. beer

Matt_N

9,047 posts

233 months

Monday 24th January 2011
quotequote all
The 'STOP CHECK ENGINE COOLANT' will be the level sensor in the expansion tank going, a well known problem. Might started intermitently then started coming up all the time.

The tank is about £11 from VW and it incorporates the sensor, good opportunity to change the coolant too.

Deskshare

21 posts

201 months

Monday 24th January 2011
quotequote all
powwerr said:
Hi there, hoping to see if someone can shed some light on my problem.

its a bora 1.8t AUM. over the winter the car struggled a little bit to start in the really cold mornings, occasionally throwing up a "STOP check engine coolant" msg, once turned off and back on this would go away.

Now, when i go to start the car it really stuggles to crank. I put a brand new decent spec battery in last week, still the same.

turn the key- turns over very slow(as if battery is low)- keep key turned and it slowly gathers momentum to crank and fire. About 5secs to start.

Alternator only charging a little? Starter motor? ???

Any info greatly appreciated. Thanks.
I have 100% the samething in my 1.8T started happening since end of Dec and its struggle to starts, been told the same its the probs in the coolant tank needs to be replaced, I had a look in the Haynes manual but doesnt detail how to replace the coolant tank, if anyone knows it this a DIY job for or more advanced, does all the coolant need draining ?

Matt_N

9,047 posts

233 months

Monday 24th January 2011
quotequote all
When changing the expansion tank I would use it as an excuse to change the coolant anyway, as you're going to have to top it up after.

Procedure:

Drain coolant using the drain plug on the bottom right corner of radiator (as you look at the engine from the front of the car). You may want to take the engine splash guard off before you do this.

Using some mole grips, release the spring clips on the hoses on the expansion tank. Unclip the connector plug for the level sensor.

Remove the expansion tank, I think it has 1 or 2 torx bits holding it down, I can't remember if it does or not.

Fit new tank, connect hoses.

Makesure the drain plug is done up.

Top up coolant, run engine up, check coolant is circulating properly.