Changing the Dash

[MikeE]

I want to change the dash from stainless steel to original walnut veneer. I have a new dash ready to go but no idea how to change over. Is there any instructions available anywhere and how long would it take if I focussed on doing it in one hit?

[Barry Sheene]

try this

[Marty V8]

Barry Sheene said:

try this

That blue car looks familiar

[Barry Sheene]

Well done that man, I'm about to do the opposite to the OP, would be lost without that page. (or paying though the nose for someone else to do it)

Virtual pint and kudos to you......

[gutu12]

MikeE said:

I want to change the dash from stainless steel to original walnut veneer.

will you be ebaying said stainless steel dash?

[Marty V8]

Barry Sheene said:

Well done that man, I'm about to do the opposite to the OP, would be lost without that page. (or paying though the nose for someone else to do it)

Virtual pint and kudos to you......

cheers

Just watch out for the sharp metal edges on the dash panel. The panel is particularly easy to catch on the bottom dash surround where it rises up on both sides either side of the steering wheel. You can always apply a bit of pressure to pull the top and bottom of the dash surround apart if needs be to get the panel to fit in.

Edited by Marty V8 on Sunday 1st July 23:30

[MikeE]

gutu12 said:

MikeE said:

I want to change the dash from stainless steel to original walnut veneer.

will you be ebaying said stainless steel dash?

Yes I will probably sell it, whats it worth though?