Funny noise at start up
Discussion
Having cleaned the stepper motor and changed the temperature sensor the car has been running much worse.
The worst problem is that when you turn the key it makes a funny noise for a second or so which sounds like you have still got the key turned as if it is being turned over. Yes - I am waiting until the fuel pump has primed!
It is going into Adrian Venn soon (when he gets the wishbones form the factory) so I'll get him to look at it if the problem still exists.
If it ain't broke don't fix it springs to mind????
Many thanks for any assistance.
FFG
The worst problem is that when you turn the key it makes a funny noise for a second or so which sounds like you have still got the key turned as if it is being turned over. Yes - I am waiting until the fuel pump has primed!
It is going into Adrian Venn soon (when he gets the wishbones form the factory) so I'll get him to look at it if the problem still exists.
If it ain't broke don't fix it springs to mind????
Many thanks for any assistance.
FFG
Do you find that the stepper motor sometimes makes a noise - the sort of "kkkk" that Victor Borge used to do for a comma (Phonetic Punctuation).
If so, is it this sort of noise.
I used to find that the stepper motor would make this noise if I put the key in the ignition then removed it without starting - the Battyman said it was just the stepper resetting....
If so, is it this sort of noise.
I used to find that the stepper motor would make this noise if I put the key in the ignition then removed it without starting - the Battyman said it was just the stepper resetting....
its hard to tell a noise without listening to it, the fact you have cleaned the stepper motor offen dose not relate to this, their is always somethink else (past experience) as starmist states this could be your hyd lifters when did you last change the oil? whithout actualy listening to it its a needle in a haystack senario.
Steve.......
Steve.......
this DOES sound like the stepper motor.
when the igntion is turned on, the ECU checks all then sets the stepper to allow enough air in to start/run/idle.
its kind of a buzz/whir from the back of the block (obviously) for around 2 secs and is COMPLETELY NORMAL!
get someone to turn on the ignition while you listen under the bonnet.

when the igntion is turned on, the ECU checks all then sets the stepper to allow enough air in to start/run/idle.
its kind of a buzz/whir from the back of the block (obviously) for around 2 secs and is COMPLETELY NORMAL!
get someone to turn on the ignition while you listen under the bonnet.
Gassing Station | Griffith | Top of Page | What's New | My Stuff


