Fuseboard removal on pre-cat griff

[FactBV]

Just wanted to take the fuse board out to do a couple of things. The battery is out and I have removed the nut below and centre to the board itself. It is coming free and in fact the bottom part of the fuse board will pull out almost until it clears the fibreglass surround but it feels as if it is hinged on the top or there is a clip there. Before I do something stupid and crack it is there something that I have not done? Thanks Peter.

[spend]

Fuse box is cable tied into the 'holder'. Easiest way is to undo the fibreglass frame from the wheelarch ~ 2 bolts from the footwell with spanner in the wheelarch by the tyre. The loom also tends to be cable tied to that 'holder' so it's much easier to unbolt the whole thing as a unit.

[carsy]

There are to nuts and bolts. The clearly visible one, centre bottom holds the fusebox to the fibreglass surround. As you look at it there is another one to the left by a cm or so. This bolts the lot to the wheelarch. Other than that the only other thing which holds the board and surround together is a couple of tie wraps.

[FactBV]

Perfect, thanks guys.