won't start
won't start
Author
Discussion

mf68

Original Poster:

199 posts

254 months

Tuesday 6th June 2006
quotequote all
to cut a long story short
i fitted a new carpet set last week and went to use the car sunday and it turned over but would not start, on the second attempt noticed that i could not hear the fuel pump prime.
a read of the bible so i decided to check the inertia switch as i had been crawling in spaces i didnt know exist to fit the carpet, removed the glove box and made sure the switch was pulled up sic pic



still could not here the pump prime.
Also switched the alarm on and off as suggested in the bible
next step i decided to pull the fuse box out as i had took this out to fit the carpet and check for loose wire's and
then had another go at starting and still no prime so went back to the fuse box and noticed that the relay hilighted in the next pic was quite warm


in the owners maual this is described as the courtesy light delay unit
where as the relay for the fuel pump is said to be sitting on the top of the battery next to the ecu have had visual look at them and touched and no heat.
just wondering if the relay hilighted in the above pic could be cause as not to electricly inclined
close up pic







sorry about pic quality as used the phone camera.
any advise appreciated
cheers
martin

ps taken offending relay out to be safe




Griffter

4,143 posts

284 months

Tuesday 6th June 2006
quotequote all
I think I'm right in saying that the fuel pump cut off ('inertia') switch should be DOWN...I hope it's that easy!

Edited by Griffter on Tuesday 6th June 22:33

GreenV8S

31,017 posts

313 months

Tuesday 6th June 2006
quotequote all
Griffter said:
I think I'm right in saying that the fuel pump cut off ('inertia') switch should be DOWN...I hope it's that easy!


Yes, you're right. And it is normal for relays to get warm in use.

mf68

Original Poster:

199 posts

254 months

Wednesday 7th June 2006
quotequote all
cheers
will push it down when i get home tonight and give it a go, for some reason had it in my head that it has to be up
martin

mf68

Original Poster:

199 posts

254 months

Wednesday 7th June 2006
quotequote all
cheers Griffter and Green V8s
you were both correct the interia switch has to be pushed in, so must have pushed it up a bit when fitting the carpet some how and came to the conclusion that it should be pulled out, pushed it in and it fired up straight away.made me a very happy man .
was beging to fret as not electricaly minded

cheers
martin

Edited by mf68 on Wednesday 7th June 18:44