Drain holes?

[Aussie John]

Should the space below the headlight pods have any drain holes? Anybody seen some? cheers, John.

[spend]

Do you mean in the undertray? My Chim didnt have any ~ but a drill quickly corrected that

I put them in the lowest parts of the corner pieces by the wheelarch & under the rad. Washed car (omly the once BTW) on level ground so you you can see where the water collects was my simple strategy....

Dave

[Aussie John]

I guess its in the same area but just to either side of the rad is a sort of seperate section which looks as if it should have holes. If no one comments against this then in go the holes. Thanks Dave.

[seasider]

spend said:

Do you mean in the undertray? My Chim didnt have any ~ but a drill quickly corrected that

I put them in the lowest parts of the corner pieces by the wheelarch & under the rad. Washed car (omly the once BTW) on level ground so you you can see where the water collects was my simple strategy....

Dave

Dont take to much weight of the front Spendy you could really mess up the balance


Especially with the extended oversized ae on the back of a Chimp

Aussie John said:

Should the space below the headlight pods have any drain holes? Anybody seen some? cheers, John.

I added a couple

[spend]

seasider said:

Especially with the extended oversized ae on the back of a Chimp

Is that aerodynamic@rse by any chance?

Dave

Just jealous cos you've got a lump of lard behind the rear wheels eh?

[seasider]

spend said:

seasider said:

Especially with the extended oversized ae on the back of a Chimp

Is that aerodynamic@rse by any chance?

Dave

Just jealous cos you've got a lump of lard behind the rear wheels eh?

Beautifully curvaceous


Rather than elongated to accommodate ball hitting equipment

[spend]

seasider said:

Rather than elongated to accommodate ball hitting equipment

At least we dont try to put the square peg in the round hole

Dave

Metric RV8 hahahahahahahhahahahah - tried to keep that one quiet eh?

[seasider]

spend said:

seasider said:

Rather than elongated to accommodate ball hitting equipment

At least we dont try to put the square peg in the round hole

Dave

Metric RV8 hahahahahahahhahahahah - tried to keep that one quiet eh?

Schhh.... i didn't have a 5/16" coil to try in (till today) & it screwed in the M8 ok last night (ok.... after i'd had a beer). Sorted now, & no coil

[spend]

Mums the word...

Dave

For now....

[Jay Ayegees]

Hi

The space below the headlight pod on the nearside holds the heater blower so holes there might not be advisable.

Jay

[seasider]

Jay Ayegees said:

Hi

The space below the headlight pod on the nearside holds the heater blower so holes there might not be advisable.

Jay

Might help it blow some cooler air in the summer

[spend]

Is that really where the blower is anyway.....?

Dave

[Jay Ayegees]

Spend

Yes - I wasn't half surprised to see it there when we took the nearside headlight pod out when I fitted the SE pods during a recent respray. Blows air up over the n/s wheelarch and into the dash above the glovebox.

The wonder of TVRs!

Jay