Discussion
Suggest you renew the sealant round the clutch fluid reservoir, seal round the VIN plate, seal all things that pass through the bulkhead, and finally put some sealant on the pop rivets that hold the windscreen/bonnet hinge assembly to the bodywork (only really accessible from under the dash). If in doubt, dob it on!!!
Alan
Alan
Every thing and I mean every thing that goes through both the inner wings under the bonnet needs to be sealed. Even if it looks OK, if your getting leaks then remove, clean and reseal.
Don’t forget under the inlet hose from AFM to Plenum there is an access panel to the back of the fuse board.
I use ordinary black silicone sealant from B&Q its cheap and easy to get hold of and it works.
Cheers,
Simon.
(removed the vegetable referance)
Don’t forget under the inlet hose from AFM to Plenum there is an access panel to the back of the fuse board.
I use ordinary black silicone sealant from B&Q its cheap and easy to get hold of and it works.
Cheers,
Simon.
(removed the vegetable referance)
Edited by simon.b on Tuesday 24th April 13:06
Edited by simon.b on Tuesday 24th April 13:07
Gassing Station | Griffith | Top of Page | What's New | My Stuff


