Do Cerbera PAS transfer hoses fit a griff / Chimaera?

[monstergrowler]

I have had to remove my PAS as it started leaking badly. Unfortunateley there was no way I could remove it with the PAS copper transfer pipes inplace. They didnt want to come undone on the rack end, despite trying everything for hours.
In the end I had to resort to sawing them off.
I now need new transfer pipes and fittings. Does anyone know if the fittings are standard and where I can get them from or alternatively I have been advised by a helpful fellow member that the Cerberea flexible ones may fit. Does anyone out there know if they fit or have tried somwthing else as it would make it much it much easier allround?
thanks.

[Uncle Fester]

I have one pipe that leaks slightly. Topping up keeps it ok, but I started looking for a replacement.

Clever Trevor emailed me back and said they could get one. I think they were getting it made up.

A local place (Kent) that I use said they knew where to get one made. When the car is with them next I was going to get it done.

If you find a place with them off the shelf, let me know. I emailed Racing Green and they said leave it with them, but it might take some time.

[HRG]

Can you post a pic of the fitting up? Add that to the spanner size and I'm sure we can id it Might also help if you can measure the TPI (teeth per inch) and outside thread diameter. The pipes are only swaged and bent tube, nothing overly special.

[Fat Griff]

If you want some power steering pipes made up, try these guy's Pirtek 01332 205000. used them in the past, great job and service.

[SI 4.3]

I have also used Pirtek in the past, will come to you make up what you need and fit it at reasonable cost.
Simon

Edited by SI 4.3 on Wednesday 28th May 19:20