fitting rear anti-roll bar

[kabaman]

I've collected the bits to fit a rear anti-roll bar to my Griff 4.0. I think I have all the bits but I'm puzzled. The wishbone ends are obvious enough...My question is at the chassis part. I have the curved brackets that go around the bush. I have a flat plate that the curved section bolts on to. I can't see an obvious means off attaching the flat plate to the chassis although it has two holes.

Do I need to make and weld brackets or are there yet more bolt on brackets I don't have yet? If anyone has good pic of how this fits together on a Griff 500 could they please post it here or to my email address.

Thanks in advance for any help,

Neil

[kabaman]

Apologies, I think I've sorted it out, if anyone has a good pic I'd still be interested though, thanks, Neil

[CLN1]

Neil

Email me on [e-mail] and I'll send you some photos