Topping up my spare parts bin
Topping up my spare parts bin
Author
Discussion

Barreti

Original Poster:

6,689 posts

266 months

Saturday 13th February 2010
quotequote all
I have a chance of getting a few bits at a good discount from a friend of a friend who owns a motor parts place, so can anyone tell me if the clutch master and slave cylinders on a pre-cat Griff with LT77 box is standard Rover LT77 stuff or TVR specific?
I think I'll get a new slave and a seals kit for the master for my spares box.

And the ignition amp - is that just boggo LR too for the type that bolts to the dizzy?

Coil - again, bog standard RV8 ?

Any suggestions for other little non-TVR specific bits I could get while I have the chance?

Relays ?

Edited by Barreti on Saturday 13th February 13:53

The AJP Griff

4,360 posts

284 months

Saturday 13th February 2010
quotequote all
Clutch master is TVR specific,but only because they changed the outlet thread size,outlet bore size and pushrod thread.If your handy with a tap and drill it's easy to convert the generic casting and use your old pushrod(8mm thread instead of generic imperial thread).If you'd like a new TVR pushrod i have quite a few and would be happy to sell them for £1 plus postage.The slave is SD1 i think,but compare them as they are a few variations with these.The coil and module are std landie stuff.

Edited by The AJP Griff on Saturday 13th February 14:39


Edited by The AJP Griff on Saturday 13th February 14:40

Barreti

Original Poster:

6,689 posts

266 months

Monday 15th February 2010
quotequote all
Thanks very much for your help Mike.
I'm not sure its worth messing about with the master at this stage then.
As for the slave - if I get a photo from under the car they should be able to recognise it from the other variants just by looking at it?

The AJP Griff

4,360 posts

284 months

Monday 15th February 2010
quotequote all
Barreti said:
Thanks very much for your help Mike.
I'm not sure its worth messing about with the master at this stage then.
As for the slave - if I get a photo from under the car they should be able to recognise it from the other variants just by looking at it?
I dont think i'd want to chance a photo of the slave to be honest,better off comparing the actual part if you can as from memory some are very similar i thinkscratchchin.

LordGrover

34,164 posts

241 months

Monday 15th February 2010
quotequote all
Is it not Q0056 here for example: click?

Edited by LordGrover on Monday 15th February 21:23

jesfirth

1,743 posts

271 months

Tuesday 16th February 2010
quotequote all
distributor, rotor arm, cap
throttle cable
fan or serpentine belt

Barreti

Original Poster:

6,689 posts

266 months

Tuesday 16th February 2010
quotequote all
Thanks,

Whats the throttle cable off?

Dizzy, now theres a thought...