Routing hose from Expansion tank to swirl tank

[roseytvr]

Finally putting her back together today - should be on the road by tea time!!! Fitting the expansion tank I have forgotten the route of the hose to the swirl tank. If I can explain:
At the bottom of the expansion tank the hose is very tight to the anti roll bar and radiator - do I feed it through the gap between rad and roll bar even though it does seem very tight or does it run along the top of the anti roll bar, which means the bend in the pipe is very sharp at the bottom of the expansion tank.
Can anyone have a butchers at theirs for me this am and let me know please?
Cheers
Ian

[JKY]

Over anti roll bar then inside chassis.

[roseytvr]

Thanks for a quick response JKY - might still get it running today!!

[TVR Beaver]

My pipe went between the fan cover and the anti-roll bar... but as you say it's close to squished flat... so I made some spacers for the tank sat it about 10mm higher... now the pipe comes out and bends over the top of the bar no problem... (and it's lot's easier to get off!!)

[Hedgehopper]

Just to show that all Griffs are different.

[roseytvr]

Guess anyhow is the answer - I can do anyhow!! Thanks