Good news.....bad news
Good news.....bad news
Author
Discussion

rigga

Original Poster:

8,806 posts

230 months

Saturday 17th April 2010
quotequote all
Good news is the car flew through the mot today without a hitch biggrin..... bad news is that after the car has been on axle stands all week whilst ive been checking it over,i now have a fair bit of play on the clutch pedal which im pretty sure it never had before,i can select all gears but have had to move the mat from under the pedal in order to get enough travel to dissengage the clutch,drive ok on the move too,just has around a inch and a half free play before any resistance is felt,so im thinking it needs bleeding,but unclear as to why now when it from memory wasnt like that before i raised it up....surley jacking the car up a corner at a time is not enough of an angle to allow air to be introduced into the line ? ill need to take the cover off and have a look at the level,but i had the fluid changed at the last service less than 2k ago,so would hope it was ok.

rigga

Original Poster:

8,806 posts

230 months

Saturday 17th April 2010
quotequote all
Done a search and it seems the clutch fluid res does not actually sit vertical on these cars,can anyone confirm this or not ? This may have a bearing on my issue.


edited as i had my axis confused

Edited by rigga on Saturday 17th April 22:35

rigga

Original Poster:

8,806 posts

230 months

Sunday 18th April 2010
quotequote all
Well had a look and the res was indeed empty..... no signs of any leaks external or inside the car,refilled which in all honesty wasnt a great deal as its a small chamber,bled the system and all seems ok,bit baffled to be honest,quick roadtest has revealed nothing out of the ordinary,so off to the local TVRCC meet and shall keep an eye on things.

3024E

483 posts

214 months

Sunday 18th April 2010
quotequote all
I had exactly the same on my first griff, it would empty over winter with no signs of it on the garage floor...weird.

It kept doing it quicker and quicker eventually i had to fit a new clutch slave cylinder, and it sorted it out

ok