temp gauge and heated mirrors troubles...
Discussion
Hi, I have a temp gauge on my newly aquired 500 that moves about like a windscreen wiper! it is anywhere between 50 and 90 when warmed up, the fans work as they should and the engine runs fine (checked the temp with IR gun and is ok).
I have found the ECU and otter switch water temp sensors, but cannot find the water temp sensor for the dash gauge, the bible does not help. I think the sensor is defective and i want to change it, anyone had this problem?
Also the heated mirrors come on and off at will, all by themselves....whats going on here!!
Any advice would be appreciated.
Dave
I have found the ECU and otter switch water temp sensors, but cannot find the water temp sensor for the dash gauge, the bible does not help. I think the sensor is defective and i want to change it, anyone had this problem?
Also the heated mirrors come on and off at will, all by themselves....whats going on here!!
Any advice would be appreciated.
Dave
As has been said the sender is tucked down behind the distributor near the thermostat housing. Tricky to get to, it may just be loose or not making a very good connection.
Also check your water is topped up - if it's a bit low then it might be that the sender isn't always in water, giving you that variable reading.
The wire that goes to the sender has a resistor in line (22ohm from memory on mine). It runs in the loom on the nearside of the engine behind the rocker cover.
Also check your water is topped up - if it's a bit low then it might be that the sender isn't always in water, giving you that variable reading.
The wire that goes to the sender has a resistor in line (22ohm from memory on mine). It runs in the loom on the nearside of the engine behind the rocker cover.
I'll have a look behind the distributer tomorrow, is it possible to replace it without taking the distributer out?
There is a temp sensor next to the ECU one pointing upwards but its not connected and i could not find any sign of a wire to go on it, is this normal or just usual wacky TVR way of bunging up the unused hole!
Also my heated mirrors switch on all by themselves with the fan off!
There is a temp sensor next to the ECU one pointing upwards but its not connected and i could not find any sign of a wire to go on it, is this normal or just usual wacky TVR way of bunging up the unused hole!
Also my heated mirrors switch on all by themselves with the fan off!
Gassing Station | Griffith | Top of Page | What's New | My Stuff


