Won't start
Won't start
Author
Discussion

lazyitus

Original Poster:

19,931 posts

295 months

Friday 28th January 2011
quotequote all
Bloody Hell frown

Unlock door with key fob, sit down, turn key, pump primes... then nothing.. wont even turn over even though there's plenty of battey power.

Help. Please..

Colin RedGriff

2,541 posts

286 months

Friday 28th January 2011
quotequote all
Any sound of the solenoid on the starter clicking?

lazyitus

Original Poster:

19,931 posts

295 months

Friday 28th January 2011
quotequote all
No. Just a deadly silence.

FlipFlopGriff

7,144 posts

276 months

Friday 28th January 2011
quotequote all
I had this and it was the damn hot start relay had dropped out, but as it wasn't in the footwell all looked fine. Put another relay in and boom.
FFG

Barreti

6,689 posts

266 months

Friday 28th January 2011
quotequote all
Got a 100a fuse in yours Lazyitus?

Or it could be a loose or kaked up wire to the starter.

Can't remember if the fuel cutoff under the dash will stop the car turning over but I doubt it. Worth checking but it might be a red herring.


DVR 64

13 posts

199 months

Friday 28th January 2011
quotequote all
Hi Jon,sounds like your starter solenoid is stuck.

lazyitus

Original Poster:

19,931 posts

295 months

Friday 28th January 2011
quotequote all
FlipFlopGriff said:
I had this and it was the damn hot start relay had dropped out, but as it wasn't in the footwell all looked fine. Put another relay in and boom.
FFG
Where would I find this ?

Barreti said:
Got a 100a fuse in yours Lazyitus?
Yes, but surely the pump wouldn't prime if it was this? I dunno..

DVR64 said:
Hi Jon,sounds like your starter solenoid is stuck.
Quite possible as somebody else has mentioned this. Can you bump start if this is the case ??


Thanks so far...



quattrophenia

1,103 posts

227 months

Friday 28th January 2011
quotequote all
Was that you with the bonnet up in the retail park in crewe yesterday afternoon?
Was going to stop but I had a very dirty springer on board and had no tools.
Hope you resolve the issue.

737 FLF

173 posts

202 months

Friday 28th January 2011
quotequote all
Dodgy ignition switch?

Used to happen to mine too from time to time.

Installed a bypass switch with a direct feed to the starter and it would start every time.

Eventually got round to replacing the ignition switch and since then, no further problem.

Green Meanie

484 posts

247 months

Friday 28th January 2011
quotequote all
Hi
Does everything go off at this point ie:clock stops,ignition light goes out, windows wont work etc.

If this is the case then it could be a bad main chassis earth,this happened to me I only started the car and then backed out of the garage and stopped it then NOTHING.Checked battery etc and it turned out to be a high resistance in the main chassis earth,made up a new cable larger than the original with more strands of copper in it and no problem after that.

Just a suggestion G.M

DVR 64

13 posts

199 months

Friday 28th January 2011
quotequote all
Hi Jon,i usually jack the car up a tap the solenoid with a nylon hammer while someone else tries the key.If that works then its a new starter. But check the connections on the solenoid for corosion first.If no joy give us a shout and i will nip over,only half mile away.Regards,Dave.Also forgot to mention while car is jacked up you can check for 12v at the solenoid on crank request[turn key to start]if no 12v then the problem is further back.

Edited by DVR 64 on Friday 28th January 15:56

lazyitus

Original Poster:

19,931 posts

295 months

Friday 28th January 2011
quotequote all
Thanks everyone, so far..

quattrophenia said:
Was that you with the bonnet up in the retail park in crewe yesterday afternoon?
No! Wasn't me.

DVR 64 said:
Hi Jon,i usually jack the car up a tap the solenoid with a nylon hammer while someone else tries the key.If that works then its a new starter. But check the connections on the solenoid for corosion first.If no joy give us a shout and i will nip over,only half mile away.Regards,Dave.Also forgot to mention while car is jacked up you can check for 12v at the solenoid on crank request[turn key to start]if no 12v then the problem is further back.
Going to give this a try tonight, will let you know the outcome in due course..

Cheers

Colin RedGriff

2,541 posts

286 months

Friday 28th January 2011
quotequote all
I had something similar recently. Car started fine and drove to work. Come to take it out at lunch time and nothing from the starter. Kept trying all afternoon but had to get a push start eventually.

When I got home - all fine again confused

Don't know that I have fixed it but I pulled out the birds nest in the footwell and redid all the connections for the hot start - replaced the choc blocks with soldered connectors. Took out the starter and cleaned all the connections, also replaced the 100A fuse and holder.

So far it hasn't reoccured but I've only used it a few times. Sunday will be the test when I want to go to the Sunday Service...... (any other day it wouldn't matter)

lazyitus

Original Poster:

19,931 posts

295 months

Friday 28th January 2011
quotequote all
Managed to bump start it, so assuming it's the starter/solenoid. Will give it a look over and clean asap but it's stranded at work now until Monday. rolleyes

Edited by lazyitus on Saturday 29th January 01:08

lazyitus

Original Poster:

19,931 posts

295 months

Monday 31st January 2011
quotequote all
biggrin

Loose connection to starter motor, that's all.

Fixed, working. Pleased.

Thanks for everyones input. thumbup

Barreti

6,689 posts

266 months

Monday 31st January 2011
quotequote all
Barreti said:
Got a 100a fuse in yours Lazyitus?

Or it could be a loose or kaked up wire to the starter.

Can't remember if the fuel cutoff under the dash will stop the car turning over but I doubt it. Worth checking but it might be a red herring.
bowtie