Heater control unit - blower stays on
Discussion
Hi guys,
Have been doing some digging "search function" and found the following link: http://www.pistonheads.com/gassing/topic.asp?h=0&a...
Basically, I have exactly the same symptoms (my controls don't do anything and heater fan runs all of the time when ignition is on) and the connection ribbon that is referred to in the link is attached to the Heater control unit (is this the same as heater control ECU?) but not connected at the other end.
Can anyone tell me where the other end of the ribbon goes?
I suspect it goes to on the aluminium knobs etc, if this is the case, does anyone know how you get the centre console out to get access to the control knobs?
Thanks for any help!
Have been doing some digging "search function" and found the following link: http://www.pistonheads.com/gassing/topic.asp?h=0&a...
Basically, I have exactly the same symptoms (my controls don't do anything and heater fan runs all of the time when ignition is on) and the connection ribbon that is referred to in the link is attached to the Heater control unit (is this the same as heater control ECU?) but not connected at the other end.
Can anyone tell me where the other end of the ribbon goes?
I suspect it goes to on the aluminium knobs etc, if this is the case, does anyone know how you get the centre console out to get access to the control knobs?
Thanks for any help!
To get the centre console out you have to undo the bolts holding down the back end. they are enderneath the 'whale tail' behind the seats.
You'll need to loosen of the handbrake cable using the adjuster near the diif so that you can raise the hand brake up so it is vertical Remove the gear knob.
Lift the back of the console up and slide it back (it may be a bit sticky if it's not been removed before). Take care with te cable as you pull it back
This is from memory so hopefully I've not forgotten anything crucial
You'll need to loosen of the handbrake cable using the adjuster near the diif so that you can raise the hand brake up so it is vertical Remove the gear knob.
Lift the back of the console up and slide it back (it may be a bit sticky if it's not been removed before). Take care with te cable as you pull it back
This is from memory so hopefully I've not forgotten anything crucial
Gassing Station | Griffith | Top of Page | What's New | My Stuff



