high revs
Author
Discussion

chalky BV

Original Poster:

12 posts

215 months

Tuesday 26th April 2011
quotequote all
hi guys out in the griff on sunday and she decided to play up for the first time on the outward journey she was fine but on the way home when i dipped the clutch the revs would stay very high so pulled over after a time the revs would go down to tick over but had to do this three times but when i got home she sat and ticked over in the drive as sweet as a nut cleaned stepper motor went out again and still a problem (shes a 92 4.3 bv)any ideas please

blitzracing

6,422 posts

249 months

Wednesday 27th April 2011
quotequote all
If its not the stepper it can be throttle pot out of adjustment, or the TVR speedo recalibration unit producing a speed signal even though the car is stationary,(dodgey TVR electronics) so the ECU holds the idle high. I dont know if all TVRS have these however.....

srebbe64

13,021 posts

266 months

Wednesday 27th April 2011
quotequote all
Griffs are not female!

jfjfjf2

155 posts

200 months

Wednesday 27th April 2011
quotequote all
Mine is. Stubborn, contrary but sometimes utterly adorable.

JF

LordGrover

34,163 posts

241 months

Wednesday 27th April 2011
quotequote all
Mine did this whenever the ecu and/or battery were disconnected. It resets the ecu or something and takes a while to re-learn when you've stopped and it's time to drop the idle. Before you try 'fixing' anything, leave it for a dozen run outs or so - it may well disappear.

davep

1,157 posts

313 months

Wednesday 27th April 2011
quotequote all
Could be heat related. Try relocating your ECU somewhere cooler in the footwell, instead of jammed down the side of the battery box.

chalky BV

Original Poster:

12 posts

215 months

Thursday 28th April 2011
quotequote all
thanks everyone for your help all being well i might see some of you at the growl

EGB

1,774 posts

186 months

Thursday 28th April 2011
quotequote all
Try cleaning the seating of the stepper, as well as the nose of the stepper.

Pasco

6,652 posts

257 months

Friday 29th April 2011
quotequote all
EGB said:
Try cleaning the seating of the stepper, as well as the nose of the stepper.
Check this first B4 the pot yes

myph

68 posts

200 months

Friday 29th April 2011
quotequote all
I had similar problem last year turned out to be sticking trottle cable, oiled /greased everything, not been a problem since.