Fecking drive flanges

[thinfourth]

Mine are rusted onto the drive shaft on the front and the bearings are shot so i need to cut the feckers off


ARSE

[ramthorne]

Oh well, think of all the time you have saved in the past by not servicing it.

A bit of copper grease on the spline gives a fair bit of protection even if the water gets in.

[thinfourth]

I bought it 9 months ago

So not my fault honest gov

[p100]

Try applying some heat. If the bearings are fuggered anyway it will not damage them anymore!
Cheers Roy

[thinfourth]

too late

chain drill round the center bit then ground off the top and bottom of remaining bit and then knocked it off with a chisel. Lots of rust on splines but they should clean up. if not new CVs from paddock costing next to bugger all