Sky Q mini box
Author
Discussion

James_B

Original Poster:

12,642 posts

288 months

Sunday 7th October 2018
quotequote all
After a terribly botched Sky Q installation I could do with some help.

The Sky box is three floors from my television, in a cupboard in the laundry room. The Sky Router is there too.

Pending a relocation I’d like to put the Sky Q mini box in the TV room and use that. I set it up next to the main box to check that it worked, but when I move it to the TV room it tells me that it has lost contact with the main box.

It can see my (non-Sky) Linksys mesh network fine, which is the one that the Sky box is on, but can’t see the box itself.

Any ideas what’s going on?

norush

298 posts

171 months

Sunday 7th October 2018
quotequote all
Why would you not get a Sky "engineer" to sort out the problem; after all you're renting the sky q equipment? Where is the booster box in your setup; it needs to be roughly halfway between the main sky q box and the mini box?

Your make of router is immaterial; I'm using a smart hub 6 on Plusnet fibre and it all works a treat! It does help if your au fait with network stuff though; good luck!

LeadFarmer

7,411 posts

162 months

Sunday 7th October 2018
quotequote all
Pretty sure theres a removable cover on the rear of the boxes so you can connect them by ethernet cable?

tribbles

4,176 posts

253 months

Sunday 7th October 2018
quotequote all
I don't think it's got a cover to be removed!

I used Ethernet until I moved last week - and that's only because I haven't finished running new cabling through the house. Once that's done, it'll be back to Ethernet.

The mini box and main boxes are one floor away, so the wireless connection isn't too bad. At the old house, I would suffer from dropouts that also affected my normal wifi.

UpTheIron

4,058 posts

299 months

Sunday 7th October 2018
quotequote all
Are you using any wired switches between the Sky Q boxes and the WiFi network?

I'll need to look up the issue but I have encountered switches that lack the necessary support for something or other....

James_B

Original Poster:

12,642 posts

288 months

Sunday 7th October 2018
quotequote all
norush said:
Why would you not get a Sky "engineer" to sort out the problem; after all you're renting the sky q equipment? Where is the booster box in your setup; it needs to be roughly halfway between the main sky q box and the mini box?

Your make of router is immaterial; I'm using a smart hub 6 on Plusnet fibre and it all works a treat! It does help if your au fait with network stuff though; good luck!
They have sent three. Each has turned up and explained that they don’t know why they’ve sent them to do a job with a communal feed as they can’t work on those.

Each had written in their job sheet that it was communal, but rather than query it with management thought it better to turn up, apologise at the door, and leave.

I prefer now to see if I can find a workaround while I wait for an appointment with a local firm who know what they are doing.

James_B

Original Poster:

12,642 posts

288 months

Sunday 7th October 2018
quotequote all
UpTheIron said:
Are you using any wired switches between the Sky Q boxes and the WiFi network?

I'll need to look up the issue but I have encountered switches that lack the necessary support for something or other....
No, Sky box has Ethernet connection to the Linksys mesh base station, and the mini box is connected the mesh network.

smashie

685 posts

182 months

Monday 8th October 2018
quotequote all
I had Sky Q installed the other week at home.
The main box connects to your wifi, the minis do not communicate to the main box through that wifi. They communicate via it's own wifi network from the main box.
If you have a sky router, then it can use that wifi. No matter how great your home wifi is, it will not be used to link the boxes together unless it is a sky router.
To link the minis together you have a few options.
1 - ethernet cable
2 - Ethernet over power jobbies.
3 - Ethernet to wifi bridge between the main and minis.

Either way, it looks like you will need to use the ethernet port unless you have a sky router.

Whoozit

3,891 posts

300 months

Monday 8th October 2018
quotequote all
Sky will fit a repeater box for the Sky Q wifi system, if the Mini doesn't get a good enough signal. Ask them to sort one. Shouldn't have to touch a communal feed.


AMST09

570 posts

211 months

Monday 8th October 2018
quotequote all
They are crap, we had ours in the lounge and 1 in the bedroom above and had to balance it on top of the TV to get signal
They don't use your wireless network to connect, sky will come and put a booster in which they should do when they install it if necessary
Theres a few other works arounds but they all seemed like bodges when I looked into it
Don't particularly like Virgin but at least the boxes are hardwired

James_B

Original Poster:

12,642 posts

288 months

Monday 8th October 2018
quotequote all
smashie said:
I had Sky Q installed the other week at home.
The main box connects to your wifi, the minis do not communicate to the main box through that wifi. They communicate via it's own wifi network from the main box.
If you have a sky router, then it can use that wifi. No matter how great your home wifi is, it will not be used to link the boxes together unless it is a sky router.
To link the minis together you have a few options.
1 - ethernet cable
2 - Ethernet over power jobbies.
3 - Ethernet to wifi bridge between the main and minis.

Either way, it looks like you will need to use the ethernet port unless you have a sky router.
Thanks.

That’s going to be a real problem; the signal is not going to work three floors away and I don’t have Ethernet running to the TV room.

I’ll have to wait until I get the original installers in who did the street when it was new to get it working.

LocoBlade

7,653 posts

287 months

Monday 8th October 2018
quotequote all
Although both Sky Q boxes are connected to your home Wifi it only uses that for internet access for catch up TV etc, they create their own separate mesh network to distribute content from the Sky Q box to the Minis so just because you can see your Linksys Wifi in both locations doesnt mean the two boxes can see each other to make a connection. As mentioned above the best bet if Ethernet isnt an option is to get Sky to supply a repeater/booster box that will sit in the middle and allow the two to talk.

James_B

Original Poster:

12,642 posts

288 months

Monday 8th October 2018
quotequote all
LocoBlade said:
Although both Sky Q boxes are connected to your home Wifi it only uses that for internet access for catch up TV etc, they create their own separate mesh network to distribute content from the Sky Q box to the Minis so just because you can see your Linksys Wifi in both locations doesnt mean the two boxes can see each other to make a connection. As mentioned above the best bet if Ethernet isnt an option is to get Sky to supply a repeater/booster box that will sit in the middle and allow the two to talk.
Does such a thing exist, and do you know how I’d set it up?

Edited to say, I see that there is an official Sky booster.

I suspect that any booster with WPS would work, but have ordered the Sky one to be sure.

Edited by James_B on Monday 8th October 22:16

MissChief

8,021 posts

199 months

Tuesday 9th October 2018
quotequote all
James_B said:
LocoBlade said:
Although both Sky Q boxes are connected to your home Wifi it only uses that for internet access for catch up TV etc, they create their own separate mesh network to distribute content from the Sky Q box to the Minis so just because you can see your Linksys Wifi in both locations doesnt mean the two boxes can see each other to make a connection. As mentioned above the best bet if Ethernet isnt an option is to get Sky to supply a repeater/booster box that will sit in the middle and allow the two to talk.
Does such a thing exist, and do you know how I’d set it up?

Edited to say, I see that there is an official Sky booster.

I suspect that any booster with WPS would work, but have ordered the Sky one to be sure.

Edited by James_B on Monday 8th October 22:16
Sky would have sent an Engineer FOC who would have fitted one to get the mini box working, again FoC. You shouldn't have to buy one.

James_B

Original Poster:

12,642 posts

288 months

Tuesday 9th October 2018
quotequote all
MissChief said:
Sky would have sent an Engineer FOC who would have fitted one to get the mini box working, again FoC. You shouldn't have to buy one.
As I say above, they have sent three so far, none of whom came close to getting the system working. The only one that achieved anything managed only to disconnect my freesat and the neighbours' sky feed.

While your faith in the ability of the monkeys that they employ suggests you are a lovely person who sees the best in the world my own experience tells me that I should do everything that I can never to let them in my house again.

I'm especially unwilling to take any more time off work to accommodate their visits. The last one called to confirm a time, then when he turned up said he had no idea why they'd sent him, as he knew from the job sheet that he couldn't do anything. I have no idea why he didn't tell me this when I called him from work, instead of having me spend an hour getting home.

PugwasHDJ80

7,684 posts

252 months

Tuesday 9th October 2018
quotequote all
James_B said:
smashie said:
I had Sky Q installed the other week at home.
The main box connects to your wifi, the minis do not communicate to the main box through that wifi. They communicate via it's own wifi network from the main box.
If you have a sky router, then it can use that wifi. No matter how great your home wifi is, it will not be used to link the boxes together unless it is a sky router.
To link the minis together you have a few options.
1 - ethernet cable
2 - Ethernet over power jobbies.
3 - Ethernet to wifi bridge between the main and minis.

Either way, it looks like you will need to use the ethernet port unless you have a sky router.
Thanks.

That’s going to be a real problem; the signal is not going to work three floors away and I don’t have Ethernet running to the TV room.

I’ll have to wait until I get the original installers in who did the street when it was new to get it working.
It is possible to force it to use your own WifI connection- its something strange like disabling the ethernet connection- there are guides on the interweb that will help

MissChief

8,021 posts

199 months

Wednesday 10th October 2018
quotequote all
PugwasHDJ80 said:
James_B said:
smashie said:
I had Sky Q installed the other week at home.
The main box connects to your wifi, the minis do not communicate to the main box through that wifi. They communicate via it's own wifi network from the main box.
If you have a sky router, then it can use that wifi. No matter how great your home wifi is, it will not be used to link the boxes together unless it is a sky router.
To link the minis together you have a few options.
1 - ethernet cable
2 - Ethernet over power jobbies.
3 - Ethernet to wifi bridge between the main and minis.

Either way, it looks like you will need to use the ethernet port unless you have a sky router.
Thanks.

That’s going to be a real problem; the signal is not going to work three floors away and I don’t have Ethernet running to the TV room.

I’ll have to wait until I get the original installers in who did the street when it was new to get it working.
It is possible to force it to use your own WifI connection- its something strange like disabling the ethernet connection- there are guides on the interweb that will help
When you reset the network connection on the menu you just choose 'non sky broadband', nothing dramatic and no force required. There's no individual option for Ethernet, the box will default to it automatically.
Without Sky Broadband the Q equipment will look to set up it's own private network for the Q equipment only. This means it will avoid using your broadband as much as possible.

James_B

Original Poster:

12,642 posts

288 months

Wednesday 10th October 2018
quotequote all
MissChief said:
When you reset the network connection on the menu you just choose 'non sky broadband', nothing dramatic and no force required. There's no individual option for Ethernet, the box will default to it automatically.
Without Sky Broadband the Q equipment will look to set up it's own private network for the Q equipment only. This means it will avoid using your broadband as much as possible.
But is that not just back to where we came in? The box and mini box are too far apart to communicate with each other directly.

I’m possibly not understanding you correctly, but it sounds like you are telling me to do what I said at the top that I can’t do.

MissChief

8,021 posts

199 months

Wednesday 10th October 2018
quotequote all
James_B said:
MissChief said:
When you reset the network connection on the menu you just choose 'non sky broadband', nothing dramatic and no force required. There's no individual option for Ethernet, the box will default to it automatically.
Without Sky Broadband the Q equipment will look to set up it's own private network for the Q equipment only. This means it will avoid using your broadband as much as possible.
But is that not just back to where we came in? The box and mini box are too far apart to communicate with each other directly.

I’m possibly not understanding you correctly, but it sounds like you are telling me to do what I said at the top that I can’t do.
A booster may help, otherwise you're looking at Powerline or Ethernet. Call Sky and ask for a relocate visit for the Mini box.

eliot

12,000 posts

285 months

Wednesday 10th October 2018
quotequote all
Bookmarking thread for all future 'should i run cat x in my house' threads.