Connecting a wireless laptop to an unsecured network
Discussion
I thought it was all pretty straightforward and automatic. However, although there is a network to connect to and I get connected (albeit with a low signal) Internet Explorer just shows the 'page cannot be found' page. I thought sod it, I'll plug the laptop into the normal network connection and download some shizzle so that I can sort it out, again, it's not playing ball. The laptop fails to renew the IP when I stick the cable in, what could be the reason for this?
Kinky said:
Disable the wireless adapter and then re-start it.
Or "repair" it via the support tab on the connection status window.
K
Or "repair" it via the support tab on the connection status window.
K
I've tried repair and with the LAN cable plugged in it says that it can't renew the IP address. Could the wireless issues simply be a low signal strength? Or should it al least pick up something in IE?
Go to;
control panel
Newtwork connections right click,
properties
In the list click Internet Protocol (TCP/IP) and press configure
Make a note of your IP address and Subnet mask as you will need this again when you connect back to your home network
Then click obtain IP address automatically
Press ok and it should work
HTH
Liam
control panel
Newtwork connections right click,
properties
In the list click Internet Protocol (TCP/IP) and press configure
Make a note of your IP address and Subnet mask as you will need this again when you connect back to your home network
Then click obtain IP address automatically
Press ok and it should work
HTH
Liam
Woody3 said:
Go to;
control panel
Newtwork connections right click,
properties
In the list click Internet Protocol (TCP/IP) and press configure
Make a note of your IP address and Subnet mask as you will need this again when you connect back to your home network
Then click obtain IP address automatically
Press ok and it should work
HTH
Liam
control panel
Newtwork connections right click,
properties
In the list click Internet Protocol (TCP/IP) and press configure
Make a note of your IP address and Subnet mask as you will need this again when you connect back to your home network
Then click obtain IP address automatically
Press ok and it should work
HTH
Liam
That's already how I had it. It claims to connect to the network but then there is nothing on IE.
Gassing Station | Computers, Gadgets & Stuff | Top of Page | What's New | My Stuff




