Airport Extreme Routing - Share Single IP address?
Discussion
Decided to take the plunge with the new 802.1n Airport Extreme, using it as a wireless bridge to my ADSL modem.
I've got it all working after some pulling-out-of-hair by turning off the DHCP of the Airport and having the ADSL modem (actually a wireless router too) handle the DHCP (Airport is in 'bridge mode'). Works great - obviously can't get the maximum benefit from the x.1n mode yet but even in x.1g it gives better signal quality/range and slightly higher throughput than my old Belkin54g one.
However, port forwarding doesn't seem to work in this configuration and from reading it seems that the best way to make it work is to run the Airport in "Share a single IP address" mode, which then gives you NAT and port-forwarding settings.
Having dabbled with this setting however, I ended up reverting back to the previous way. One of the main problems is that it kept throwing up an error that said "The DHCP range conflicts with the WAN address of the base station".
I have the following setup;
ADSL modem:
IP 10.0.1.99 (I can't remember why I chose 99)
DHCP off
Airport
IP 10.0.1.1
Share single IP address
DCHP range 10.0.1.10 to 10.0.1.98
NAT on
I have several devices with fixed IP addresses (10.0.1.2 to 10.0.1.5) and a few that use DHCP to get their IP from the server.
Questions then;
1 - Am I doing something wrong with this "share single IP" malarky?
2 - Is this the best way to setup my network/internet?
Cheers
I've got it all working after some pulling-out-of-hair by turning off the DHCP of the Airport and having the ADSL modem (actually a wireless router too) handle the DHCP (Airport is in 'bridge mode'). Works great - obviously can't get the maximum benefit from the x.1n mode yet but even in x.1g it gives better signal quality/range and slightly higher throughput than my old Belkin54g one.
However, port forwarding doesn't seem to work in this configuration and from reading it seems that the best way to make it work is to run the Airport in "Share a single IP address" mode, which then gives you NAT and port-forwarding settings.
Having dabbled with this setting however, I ended up reverting back to the previous way. One of the main problems is that it kept throwing up an error that said "The DHCP range conflicts with the WAN address of the base station".
I have the following setup;
ADSL modem:
IP 10.0.1.99 (I can't remember why I chose 99)
DHCP off
Airport
IP 10.0.1.1
Share single IP address
DCHP range 10.0.1.10 to 10.0.1.98
NAT on
I have several devices with fixed IP addresses (10.0.1.2 to 10.0.1.5) and a few that use DHCP to get their IP from the server.
Questions then;
1 - Am I doing something wrong with this "share single IP" malarky?
2 - Is this the best way to setup my network/internet?
Cheers

Gassing Station | Computers, Gadgets & Stuff | Top of Page | What's New | My Stuff


