Network wire help
Discussion
Hello everyone,
I need to buy a 50m Network cable for a connection between computers (and the xbox 360). Looking on ebay, there are 2 types of wire, Straight and crossover. Which of these 2 do I need?
Is there anything else I need to know about creating a LAN?
Thanks alot,
from GFWilliams
I need to buy a 50m Network cable for a connection between computers (and the xbox 360). Looking on ebay, there are 2 types of wire, Straight and crossover. Which of these 2 do I need?
Is there anything else I need to know about creating a LAN?
Thanks alot,
from GFWilliams
Edited by GFWilliams on Tuesday 3rd July 08:01
For an ETHERNET link you need cat5 twisted pair cable. Next - how to connect - you could get plugs crimped on etc or fit wall sockets on the ends and use short patch leads. To avoid the expanse of hub - you can cross one end of the cable .( of four pairs of wires , one pair in one direction is transmit, other is recieve)
See this
http://www.incentre.net/incentre/frame/ethernet.ht...
In all cases keep twists in wire to as close as possible to termination point.
Maximum run is taken as 100m .( good quality cat 5 has length markers on sheath of cable )
See this
http://www.incentre.net/incentre/frame/ethernet.ht...
In all cases keep twists in wire to as close as possible to termination point.
Maximum run is taken as 100m .( good quality cat 5 has length markers on sheath of cable )
The ebay bod may be referring to crossover/straight connected rather than the twisted pairs inside the cable. xbox direct to PC = cat5 UTP crossover, xbox to hub/switch/router/whatever = cat5 utp straight. I assume you're buying a cable with the ends already on it? Probably best if you haven't got any stuff to put ends on with and haven't done it before, only downside is it's harder to poke through small holes with the ends on.
The bit about the ends was one reason why i suggested using sockets at each end. Patch leads are not that expensive , using sockets means that the cable end can be fed through and then the cross over can be set into the cable. Only problem is then keeping twists to end -although saying that, i have (in an emergency when an important cable got cut ) joined cat5 using a socket, and it worked quite well.
Only other problem is that DIY idc tools don't cut the wire end, so a little bit of care needs to be taken there ,otherwise there is a risk of a short circuit between wires.
Only other problem is that DIY idc tools don't cut the wire end, so a little bit of care needs to be taken there ,otherwise there is a risk of a short circuit between wires.
Gassing Station | Computers, Gadgets & Stuff | Top of Page | What's New | My Stuff


