Plotloss...... Ohms
Discussion
Hi Matt,
Hope your well?
I recently picked up an Onkyo 605 amp for £399 which apart from being used to run my surround sound (New speakers to be ordered are Jamo A102HCS5) will also be used to run Zone2 into the kitchen!
Now i'm looking at some cheap ceiling speakers and i'm a bit baffled by all this talk of Ohms! I was hoping you might be able to explain it to me in laymans terms.
According to Onkyo the 605 has a Speaker Impedance rating of 4 ohm - 16 ohm or 6 ohm - 16 ohm
No in that case am I correct in assuming that I should buy 4ohm speakers instead of 8ohm ones? Or are the 8ohm ones easier to "drive" thus putting less stress on the amp.
The speakers will be 100w 6.5inch ceiling speakers so nothing too fancy and it's for background music not for raves.
Half the kitchen ceiling is down at the moment so it seems like a good time to fit it all.
Cheers,
Phill
Hope your well?
I recently picked up an Onkyo 605 amp for £399 which apart from being used to run my surround sound (New speakers to be ordered are Jamo A102HCS5) will also be used to run Zone2 into the kitchen!
Now i'm looking at some cheap ceiling speakers and i'm a bit baffled by all this talk of Ohms! I was hoping you might be able to explain it to me in laymans terms.
According to Onkyo the 605 has a Speaker Impedance rating of 4 ohm - 16 ohm or 6 ohm - 16 ohm
No in that case am I correct in assuming that I should buy 4ohm speakers instead of 8ohm ones? Or are the 8ohm ones easier to "drive" thus putting less stress on the amp.
The speakers will be 100w 6.5inch ceiling speakers so nothing too fancy and it's for background music not for raves.
Half the kitchen ceiling is down at the moment so it seems like a good time to fit it all.
Cheers,
Phill
What that means is that the amp is rated to drive speakers in the range of 4-16 Ohms.
In laymans terms, any ceiling speaker will be fine, the Jamo architectural series, for instance, are 4ohm/8ohm switchable.
The lower the impedance, the harder the amp has to work as more of the signal is converted to drive the driver.
Most non-switchable ceiling speakers are 8 ohm.
In laymans terms, any ceiling speaker will be fine, the Jamo architectural series, for instance, are 4ohm/8ohm switchable.
The lower the impedance, the harder the amp has to work as more of the signal is converted to drive the driver.
Most non-switchable ceiling speakers are 8 ohm.
Gassing Station | Computers, Gadgets & Stuff | Top of Page | What's New | My Stuff


