Brake Master Cylinder change

[Barreti]

Following on from the exploits I've documented so far on another thread, I thought I should finally start my own for this work.

I've got a new brake master cylinder and have started putting things together - having had to reglue all the insulation stuff inside the inner wing this morning.

There is a little rubber seal on the brake servo inside the hole the brake master slots into:
I have cleaned this up thoroughly, removing all the rusty guck I found.
Should I now grease this seal before inserting and bolting on the cylinder - I have proper rubber grease available.

Ta
IanB

Edited by Barreti on Wednesday 11th May 14:27