V8 Oil pressure switch location

[.Mark]

Anyone got a picture of where it is? This job is next(ish) on my list. Also I suspect it's not a parts bin part, so best place to get one?

[Tanguero]

No picture I am afraid - but it is located in the "V" under the edge of the coil mounting plate.

[.Mark]

Thanks, will have a rummage later

[itiejim]

IIRC it's a Rover V8 one.

[optimax sniffer]

It is under the coil packs. When I did mine I took both the packs off and the mounting plate. It looks as though you can do it by only taking the rear pack off.





Racing green have 'em. RG

Intermotor part no. 50600 (10psi)

[.Mark]

optimax sniffer said:

It is under the coil packs. When I did mine I took both the packs off and the mounting plate. It looks as though you can do it by only taking the rear pack off.





Racing green have 'em. RG

Intermotor part no. 50600 (10psi)

That's a good pic, thanks. So I assume airboxes off etc?

[optimax sniffer]

.Mark said:

That's a good pic, thanks. So I assume airboxes off etc?

Not necessarily. Might be able to do it by just taking off the induction pipes and the fuel rail, but then again one box wouldn't hurt

[.Mark]

Cheers

[SimonKD]

optimax sniffer said:

It is under the coil packs. When I did mine I took both the packs off and the mounting plate. It looks as though you can do it by only taking the rear pack off.





Racing green have 'em. RG

Intermotor part no. 50600 (10psi)

Is this new plate from Power?

[optimax sniffer]

SimonKD said:

Is this new plate from Power?

Yes it was, although it came via TVR Car Parts