Something is not right!

[_Batty_]

Thinking it's my rocker gasket. Easy to do?

[Rocketman105]

_Batty_ said:

Thinking it's my rocker gasket. Easy to do?

Easy if you know how.

[Metalligator]

Just make sure you fill in the crevices, rubber doesn't make an excellent seal and you don't want seepage

[tuttle]

Hi Batty, If your experiencing some seepage from your old chap (see what I did there?) Its prob the gasket, easy enough to do. Couple of things worth remembering when doing it with yerself:

Give both sides of your covers gasket surfaces a good scraping, to get a really clean flush surface.
Little dab of silicone sealant at the corners
Re tighten your nuts in the correct sequence

[Metalligator]

Don't over tighten or the rubber doesn't seal.
Tighten in correct sequence check them all again then check again in a week ideally

[Xenocide]

Related question, the bit on the end of the LH camshaft towards the bulk head seems to be pissing oil. What to I replace to fix that? I've been told camshaft oil seals?!

[snotrag]

LH from drivers perspective?

End of your Exhausf cam? Thst will be your Cam angle sensor O-ring, presuming were talking mk1.

Replace it when you do the rocker gasket.