Heater flap fault

[ATKY]

My T350 has been in bits for about 2 years and is now just about back together.When I powered everything back up and got it running,all was ok apart from system fault 136 heater flap.The flap motor has been disconected during the rebuild and I know it will need the position resetting in the pod menu.I have replaced the motor with a new one but still have the fault 136 up.Does anyone know if anything else could be causing fault?Also what is the correct procedure for fitting and setting up a new flap motor?Regards,Steve.

[shep1001]

ATKY said:

My T350 has been in bits for about 2 years and is now just about back together.When I powered everything back up and got it running,all was ok apart from system fault 136 heater flap.The flap motor has been disconected during the rebuild and I know it will need the position resetting in the pod menu.I have replaced the motor with a new one but still have the fault 136 up.Does anyone know if anything else could be causing fault?Also what is the correct procedure for fitting and setting up a new flap motor?Regards,Steve.

Not 100% on this but the position you set the flap in when its replaced is important, flap position set from the POD menu only helps stop the hot air leak into the cabin.