Can you measure yours this weekend please

[Gerald-TVR]

As you have probably read I an attempting to identify finally chassis differences between models. To help me in the early stages it would be very helpful if people could measure a few dimensions from their chassis. While some of these can only be taken with the body off others can be done body on so please could you take what measurements you can and let me have them either here or via a PM, many thanks.

If you refer to the diagrams below you will se what I am currently after and if you could itemtify your measurements by the letter shown and the length and angle of the rear upright I would be grateful. I am aware that the angle measurement will be difficult but even a reasonable approximation would help. Also muliple readings on models will help

Thanks to Matt for some V8 dimensions Norman

[HvdWeerden]

misleading title ;-(

[Alan Whitaker]

Hi Norman.
I was going to say 10" BUT I read the post,

S1 Chassis year Jan 1988

A = 455mm
B = 185mm
C = 520mm
D = 925mm
E = 560mm
F = 480mm
G = 360mm

All are approx

Rear upright suspension leg 400mm to the top angle approx 11.5 deg

Hope this helps, will be back in the workshop tomorrow if you need any more measurements


Alan

Edited by Alan Whitaker on Saturday 11th June 13:44

[Gerald-TVR]

HvdWeerden said:

misleading title ;-(

Who's got a dirty mind then???????????

[Gerald-TVR]

Alan Whitaker said:

Hi Norman.
I was going to say 10" BUT I read the post,

S1 Chassis year Jan 1988

A = 455mm
B = 185mm
C = 520mm
D = 925mm
E = 560mm
F = 480mm
G = 360mm

All are approx

Rear upright suspension leg 400mm to the top angle approx 11.5 deg

Hope this helps, will be back in the workshop tomorrow if you need any more measurements


Alan

Edited by Alan Whitaker on Saturday 11th June 13:44

Thanks Alan