3 questions.................

[JMF894]

1) My clutch creaks like crazy when I depress/release the pedal and you can feel a slight vibration through the gear lever. Clutch works absolutely fine when driving.

2) What diameter should I expect my plenum inlet to be on the 450se? I measure 80mm outside diameter/75mm inside diameter.

3) How much coolant should be showing in the expansion tank when cold? I cannot see a min/max marking on the container.

just a few posers for you guys.......

Cheers in advance.

Jimbo

[mrzigazaga]

Hi Mate..I think i can only help with question No3..If your header/expansion tank is the same as the one used on mine and the 350s..(Ford)..then it should have a level indicator just under the cap inside..The tip should be showing..Its roughly 3/4 full, Hope this helps..Ziga

[JMF894]

Cheers ziga.

PS those chrome rocker are the b******s

[mrzigazaga]

Thanks..

[dixiebabes]

Question 1 Jim have you oiled your replacement knee joint to rule that out? Sorry couldnt resist.

Dix

[JMF894]

dixiebabes said:

Question 1 Jim have you oiled your replacement knee joint to rule that out? Sorry couldnt resist.

Dix

Every 6k Dix

[dixiebabes]

[pwd95]

Your plenum size suggests you have a proper one.

My old 450SE.....

[JMF894]

pwd95 said:

Your plenum size suggests you have a proper one.

My old 450SE.....

Nice to hear. It also has NCK stamped on there too.

[TVRleigh_BBWR]

JMF894 said:

1) My clutch creaks like crazy when I depress/release the pedal and you can feel a slight vibration through the gear lever. Clutch works absolutely fine when driving.
Jimbo

Sounds just the the release bearing, should not be a problems as long as you can handle the noise. if not your going to have to drop the box to change it.