Clutch cable again.....

[mrzigazaga]

Hi Peeps..went out there this morning and changed the clutch cable as the old one was starting to fray at the pedal end..The cable i have used is slightly thinner but seems to have done the job..Ideally one with a crimped loop at one end..Had to remove the oil filter to get to the adjuster and had to replace it as i couldnt get it off again..Screw driver job!!..
Monday im borrowing an Air box housing what the sensor plate sits on and will look into having one made out of stainless but without the side air filter access..I will be having a front 70+mm opening for a K&N fitment..Also going to heat proof it.
Still need to check and re-fit an inlet exhaust gasket but cant find any rocker cover bolts as the stainless ones i bought were 1/4" too big..Its a bit naughty as they were advertised as for 2.8 V6..Suns out so im gonna go test my cable out..Touch wood..Cheers..Ziga

[Mike Brewer]

Hope it all goes well for you zig............ Mike

[wild rover]

Just screw on a bolt, cut the bolt and uncrew,viola,thread restored. Best of Luck.