Problems that need fixing
Discussion
Well sorted the rattle out, just put some tape on the wheel centers. Replaced the N/S steering boot what a job freeing the locknut on the TRE, had autoglass round and the done a great job on the chip in my windscreen for nothing. Job list to do:- Annoying rattle somewhere inside the dash believed to be radio on carrier or something, bonnet needs loads of TLC as it looks like a dalmation after acid rain and a hot bonnet came into contact, any ideas how to sort this welcome as it looks like a respray, Car leaning to one side just at the front, I have no idea where to start on this one WEDG1EEEEEEEEE can i have a run up to see you when your home to give me some pointers please, and the piping on the drivers seat needs repair not too bad at the mo but will need sorting.
All this cause it was parked near Zig's motor. When i eventually get these jobs done the rusty nail run awaits GULP!!!!
Dix
All this cause it was parked near Zig's motor. When i eventually get these jobs done the rusty nail run awaits GULP!!!!
Dix
Well I have just bought some Yokohamas for the rear, but i'm tempted to obliterate the current rear tyres before replacing 
I need to remove the headlamps and clean up/paint the surrounds and also I noticed on the run up to Ettington that the passenger side pod wobbled quite a lot so that needs tightening up.
Then it's just the rear height /damper adjustment. Passenger side rear catching on arch as discussed in Adam's topic. May need to gring a little off the inside of the arch. Or simply lift the body and re-position it on the chassis....................simples innit?
Jimbo

I need to remove the headlamps and clean up/paint the surrounds and also I noticed on the run up to Ettington that the passenger side pod wobbled quite a lot so that needs tightening up.
Then it's just the rear height /damper adjustment. Passenger side rear catching on arch as discussed in Adam's topic. May need to gring a little off the inside of the arch. Or simply lift the body and re-position it on the chassis....................simples innit?

Jimbo
Gassing Station | Wedges | Top of Page | What's New | My Stuff



