Loose Boxster gearchange
Loose Boxster gearchange
Author
Discussion

Fizgig

Original Poster:

68 posts

242 months

Sunday 21st August 2011
quotequote all
Test drove a 2006 987 boxster 2.7. Covered around 93k, which i appreciate isn't low mileage, but wouldn't normally put me off. Very tidy car, no signs of abuse and strong engine, but the gearchange just felt "loose", it didn't snick between gears as my old 986 did. I've had a look around and can;t find anything to suggest this is a common fault, before i dismiss the car, has anyone any views on this, if its a simple bush then i may still consider it, but if its likely to be internal ( as i fear it may be) i'm walking....

nickfrog

25,491 posts

248 months

Monday 22nd August 2011
quotequote all
Sounds like a gear linkage that needs adjusting or lubricating or changing if too stretched. It's a bit of a long double cable between the stick and the box behind the engine, one cable controls side movement and the other longitudinal movement. Did you feel that the stick did not spring back in one direction or the other and that you had to assist it ?

If that's the cause, it's not a big job, just a bit fiddly as you have to remove quite a lot of fragile trim.

Obviously I might be wrong, dificult to tell from a distance !

Sifly

572 posts

209 months

Monday 22nd August 2011
quotequote all
I lost selection of 5th and 6th in my Boxster S a couple of years back, lever just flopped around as if not connected to anything! 1st to 4th still worked however. A link pin had broken or come out within the gear box!! Not a quick or cheap fix frown

MogulBoy

3,066 posts

254 months

Monday 22nd August 2011
quotequote all
The 986 OEM gear shift was't exactly the last word in snickety-snick gear changing (compared to say an MX-5) but the gear selector mechanism in the 987 is presumably the same as fitted to the standard 997 and it's not impossible that it has worn.

Quite a few people are upgrading their 9X6 cars with the 997 mechanism as it is a plug and play replacement.

They come in at least three variants: standard, short shift and GT3 (more metal parts) but all fit and even the standard one is reportedly an improvement, certainly over an old 9X6 shift, both in terms of less play and reduced throw. Plenty of info out there via Google. It's my next project! Just haven't decided which one to go for yet as I don't want anything too stiff - as was the case with one B&M short-sift kitted 986 that I tried.

Fizgig

Original Poster:

68 posts

242 months

Monday 22nd August 2011
quotequote all
cheers all... think i'll walk from this one at this point...