996 dumped all its oil
Discussion
Good morning all.
I'm not expecting an easy answer here, but currently a bit down and any ideas/words of assurance would be appreciated.
2004 996 with 36k miles, known to have a broken, sometimes rattly, exhaust baffle, passed MOT fine. Otherwise no issues, FSH etc.
400 miles from home in remote Scotland and we get a "Sensor failure" message and oil can graphic three times in a couple of minutes, for maybe five seconds at a time. Then once more some miles later. We start heading slowly home.
300 miles from home and we get a tinny rattling sound. Somewhere between a rattling exhaust and a piece of metal rapidly rattling in a drum. Pull over, sound is getting better. Engine stalls. Let it cool down. Switch back on ( possibly a risky idea, I admit, but I'm guessing exhaust ) and sound disappears completely after one minute.
Engine runs absolutely fine, all readings still normal so cruise towards civilisation at low speed.
Maybe ten miles later and the oil pressure slowly drops to 1 bar. Attempt to accelerate slowly and we get "Oil pressure low" warning briefly twice. With the second warning comes a red oil light.
Pull off road and check oil level. Lower than normal but above the minimum. Put our spare litre in and then notice a pretty rapid leak of oil from the very front of the engine - immediately in front of the foremost manifold, central left to right.
No smoke, smells, noises.
The car's recovered to home now ( three breakdown trucks, one late night, one holiday over ).
Since it'll be a day or two before we get the car diagnosed, please can anyone kindly brighten up our crap bank holiday with a "I've seen than happen and nothing to worry about" type reassurance ?
Cheers.
I'm not expecting an easy answer here, but currently a bit down and any ideas/words of assurance would be appreciated.
2004 996 with 36k miles, known to have a broken, sometimes rattly, exhaust baffle, passed MOT fine. Otherwise no issues, FSH etc.
400 miles from home in remote Scotland and we get a "Sensor failure" message and oil can graphic three times in a couple of minutes, for maybe five seconds at a time. Then once more some miles later. We start heading slowly home.
300 miles from home and we get a tinny rattling sound. Somewhere between a rattling exhaust and a piece of metal rapidly rattling in a drum. Pull over, sound is getting better. Engine stalls. Let it cool down. Switch back on ( possibly a risky idea, I admit, but I'm guessing exhaust ) and sound disappears completely after one minute.
Engine runs absolutely fine, all readings still normal so cruise towards civilisation at low speed.
Maybe ten miles later and the oil pressure slowly drops to 1 bar. Attempt to accelerate slowly and we get "Oil pressure low" warning briefly twice. With the second warning comes a red oil light.
Pull off road and check oil level. Lower than normal but above the minimum. Put our spare litre in and then notice a pretty rapid leak of oil from the very front of the engine - immediately in front of the foremost manifold, central left to right.
No smoke, smells, noises.
The car's recovered to home now ( three breakdown trucks, one late night, one holiday over ).
Since it'll be a day or two before we get the car diagnosed, please can anyone kindly brighten up our crap bank holiday with a "I've seen than happen and nothing to worry about" type reassurance ?
Cheers.
andrew said:
Good morning all.
Since it'll be a day or two before we get the car diagnosed, please can anyone kindly brighten up our crap bank holiday with a "I've seen than happen and nothing to worry about" type reassurance ?
Cheers.
Sadly not. Others will know better but that sounds like IMS failure.Since it'll be a day or two before we get the car diagnosed, please can anyone kindly brighten up our crap bank holiday with a "I've seen than happen and nothing to worry about" type reassurance ?
Cheers.
DSM2 said:
Sadly not. Others will know better but that sounds like IMS failure.
Thanks. I was hoping that the rattling having stopped and the engine running fine for a few miles would suggest something less than IMS/bearing. Sadly, having read a little more, I'm fearing you're possibly correct. sportsandclassic said:
Hi,
Can you take any pictures ?
Mike
Sorry, not easy to get a camera in there and I know that I'm showing the effect rather than the cause, but the oil was pouring from between the front edge of the anti roll bar and the trailing edge of the cross member in front of it.Can you take any pictures ?
Mike


cd1957 said:
Hi Looking at the amount of oil,its typical signs of the IMS bearing failure.UNDER NO CIRCUMSTANCES START THE ENGINE AGAIN.
Chris
Cheers Chris. I hear what you're saying - I was nervous just turning the key to release the steering lock in case I turned it too far.Chris
The oil in the picture is just what dribbled out overnight. The main leak was yesterday afternoon and most of the oil is on the M61/services. When we stopped, the leak was a continuous stream akin to a slow running tap. Each of the three successive breakdown trucks had less oil leaked onto it. Unloading the car on the drive only resulted in six small spots.
"All" in my title may be an exageration, but it's lost a lot of oil.
Bank holiday today. Stressy job interview tomorrow. Will hopefully get it trucked somewhere on Wednesday.

Sorry to hear of your troubles.
andrew said:
400 miles from home in remote Scotland and we get a "Sensor failure" message and oil can graphic three times in a couple of minutes, for maybe five seconds at a time. Then once more some miles later. We start heading slowly home.
Maybe ten miles later and the oil pressure slowly drops to 1 bar. Attempt to accelerate slowly and we get "Oil pressure low" warning briefly twice. With the second warning comes a red oil light.
Did the first message actually say 'sensor failure' i.e. the cars diagnostics picked up that it was a fault with the sensor, as opposed to the thing its supposed to be sensing?Maybe ten miles later and the oil pressure slowly drops to 1 bar. Attempt to accelerate slowly and we get "Oil pressure low" warning briefly twice. With the second warning comes a red oil light.
monthefish said:
Sorry to hear of your troubles.
Cheers.andrew said:
400 miles from home in remote Scotland and we get a "Sensor failure" message and oil can graphic three times in a couple of minutes, for maybe five seconds at a time. Then once more some miles later. We start heading slowly home.
Maybe ten miles later and the oil pressure slowly drops to 1 bar. Attempt to accelerate slowly and we get "Oil pressure low" warning briefly twice. With the second warning comes a red oil light.
Did the first message actually say 'sensor failure' i.e. the cars diagnostics picked up that it was a fault with the sensor, as opposed to the thing its supposed to be sensing?Maybe ten miles later and the oil pressure slowly drops to 1 bar. Attempt to accelerate slowly and we get "Oil pressure low" warning briefly twice. With the second warning comes a red oil light.
Yes, that's exactly right. I thought at the time it was very German to have some kind of sensor to detect the sensor failing. The message was in yellow with a picture of the oil can. Saw it four times and being rather a long way from anywhere read it very carefully.
At the time I was thinking thank heavens it's just a sensor and not a "real" failure.
One of my thoughts was that maybe a sensor disintegrated ( therefore sending back no signal to the obc, rather than an error signal ) and small bits of it found their way inside the engine. The sensor debris then rattled around the engine for two minutes. Some oil was pumped out through the sensor's hole low in the engine block. Hence the low oil warnings, but normal running. Then after a minute at rest ( whilst I measured and topped up the oil ), the majority of the oil drained to the sump and got expelled ???
Andrew, hope the interview went well.
Sorry to hear about the car ..
This is a vid of the broken bit if it is the IMS ..
http://www.youtube.com/watch?v=959Quf7kW9A
Andy
Sorry to hear about the car ..
This is a vid of the broken bit if it is the IMS ..
http://www.youtube.com/watch?v=959Quf7kW9A
Andy
andrew said:
Somewhere between a rattling exhaust and a piece of metal rapidly rattling in a drum.
I've heard this is the sound of IMS failure, like pieces being rattled around in a metal tin can.andrew said:
Switch back on ( possibly a risky idea, I admit, but I'm guessing exhausted)
Switching the engine back on and driving away may have turned a new IMS into a new engine (sorry to be blunt there). Hope the problem can be solved as economically as possible, really sorry to hear about this.911p said:
Switching the engine back on and driving away may have turned a new IMS into a new engine (sorry to be blunt there). Hope the problem can be solved as economically as possible, really sorry to hear about this.
My understanding is that once the IMS goes then it is new engine time as the bearing has already broken up and has sent shards / swarf / wee bits of bearing etc through the oil system.ETA ... sorry to read of your woes , I hope we are wrong and it is something easily fixed.
Waitforme said:
My understanding is that once the IMS goes then it is new engine time as the bearing has already broken up and has sent shards / swarf / wee bits of bearing etc through the oil system.
From my own experience an engine rebuild is also a possible outcome for an IMS failure, it really depends on the extent of the collateral damage and only a full inspection will be able to ascertain the true extent of any damage. I hope it is a simpler problem but I have to say the circulating metal death rattle you describe is all too reminiscent of my own painful experience. Best of luck.Gassing Station | Porsche General | Top of Page | What's New | My Stuff



