Grantura upright and CMW

[stopingby]

Hi,

i have been trying for a little while now to purchased parts for my grantura from Classic Motor Works (CMW) in the US but couldnt get any response and now the phone number does not work anymore...

Anyone now what is going on?

I am looking for rear upright, help !

Thks

[Slow M]

stopingby said:

Hi,

i have been trying for a little while now to purchased parts for my grantura from Classic Motor Works (CMW) in the US but couldnt get any response and now the phone number does not work anymore...

Anyone now what is going on?

I am looking for rear upright, help !

Thks

Marshall Moore said:

IMPORTANT NOTE: Due to an upcoming change in my fulltime job work schedule, starting March 27th, I will be working there Sunday through Thursday each week, which will leave Fridays and Saturdays freer for me to devote to Classic Motor Works. So, the phone number again is 540-772-2595. But the best way to reach me is by e-mail at: [e-mail].

[brittanytvr]

Hi Christophe,
some reproduction are perhaps better for racing use than old unit???you could find some
http://www.tvr-grantura.de/Meine-Grantura-Seite/re...

Christophe

[stopingby]

Slow M said:

stopingby said:

Hi,

i have been trying for a little while now to purchased parts for my grantura from Classic Motor Works (CMW) in the US but couldnt get any response and now the phone number does not work anymore...

Anyone now what is going on?

I am looking for rear upright, help !

Thks

Marshall Moore said:

IMPORTANT NOTE: Due to an upcoming change in my fulltime job work schedule, starting March 27th, I will be working there Sunday through Thursday each week, which will leave Fridays and Saturdays freer for me to devote to Classic Motor Works. So, the phone number again is 540-772-2595. But the best way to reach me is by e-mail at: [e-mail].

I know and i have seen it but tried the phone number last week from VA and this week from France and got the twicethe same answer that this number was no longer allocated.....

[Astacus]

I think this is klaus witzigs site. He is "granturas" on here. You could try a pm.

[Grantura MKI]

I more than likely will be able to help with your needs. Please PM me.
Regards,
D.

[Slow M]

Will Neil's castings work on this?

NEEEEEEEIIIIIIILLLLLLL!!!

[heightswitch]

Anything can work if you want to re-engineer the car around them!! I suspect though that as a torsion bar car it will need torsion bar uprights. everthing Thurner based is readily available.

N.

[Granturas]

Hi Neil,
you said
........everthing Thurner based is readily available.

Does it mean, that you have reproductions for the rear uprights of the
MKIII upward cars? That would interest me.

Klaus Witzig

[heightswitch]

Granturas said:

Hi Neil,
you said
........everthing Thurner based is readily available.

Does it mean, that you have reproductions for the rear uprights of the
MKIII upward cars? That would interest me.

Klaus Witzig

No, sorry I meant that everything for Thurner chassid cars are readily available, not necessarily from me! Rear uprights are readily available from a number of sources. My uprights are a little bit different and designed to accept either an M type (TR6) hub or a much stronger quaiff hub..When I get around to machining them that is

N.