996 Dashboard Illumination Question
996 Dashboard Illumination Question
Author
Discussion

996Type

Original Poster:

1,196 posts

183 months

Tuesday 13th September 2011
quotequote all
Hi - wonder if anyone in 996 ownership can help me here.

The oil pressure guage back illumination is not working on my MY 2000 dash (far RHS). Rest are fine.
After removing the binnacle, its not one of the outer Osram type bulbs in the mini-holders at fault.
I don't want to go further into the case at the moment without checking the illumination method.
I've split the case apart but to get any further means some real work so thought I would check here first!

I'm assuming there is secondary lighting buried back behind the dash dials somewhere.
I hope its not LED as this is going to be a pain. So I guess LED!

[1] Can anyone confirm the type of backlighting (LED / bulb / etc?)
[2] .....and how I would swap a defunct one on oil pressure section if it is....

Checked with a local specialist but they were unsure.
If there are dash specialists out there I can post to them for repair if required.

Also on a related note - is 4.5 a normal oil pressure reading at cold?
Manual says a little lower (3.5)at 3K RPM so I am wondering if there is too much oil in the system and if this would cause over reading or if the grade of oil is correct from last service.

Thanks in Advance if you can help me!


sticks090460

1,125 posts

189 months

Tuesday 13th September 2011
quotequote all
Don't know about illumination, but 4.5 bar at cold is what I get in my 996 C4S at start-up.

_gez_

1,013 posts

225 months

Tuesday 13th September 2011
quotequote all
This thread on Renntech might help. You might have to register to see the images.

http://www.renntech.org/forums/topic/1827-dash-bul...


t955daytona

318 posts

214 months

Wednesday 14th September 2011
quotequote all
4.5 or more cold is fine, the oil is much thicker then. The reading in the handbook (3.5 at 3k revs is when full warmed up) If you were only getting 3.5 at 3k cold you engine would be very worn.

996Type

Original Poster:

1,196 posts

183 months

Wednesday 14th September 2011
quotequote all
Thanks for the advice everyone. I had read this topic just through the internet search and glance read the text:

"The bulbs that light up the analog gauges are 3 watts. They have a green holder, which is not part of the bulb, as you can replace just the bulb. But to change these you have to open up the cluster to get to them."

I don't suppose anyone knows how deep I hav to go into the cluster?

I was about to start pulling needles off last time / exposing hidden Torx screws but thought the risk of damaging the exisiting instruments didn't warrant the fresh bulb.

At least I know its a 3 Watt standard bulb if I do proceed!

Thanks for the oil advice also. The car shows zero smoke so I expect neither over filled or issues with piston rings at this time.