Fitting new starter motor on s2 - help!
Fitting new starter motor on s2 - help!
Author
Discussion

Miss Music

Original Poster:

28 posts

229 months

Sunday 18th September 2011
quotequote all
Hi,

I'm just fitting a new Lucas starter motor onto my 944 S2 - the old one's been off a little while... This may be a long shot but has anyone any pics that might help me with which way round the cables go back on?? Stupidly have forgotten (obviously don't want to get them on the wrong way round).

Many thanks in anticipation.

Sandy59

2,733 posts

242 months

Sunday 18th September 2011
quotequote all
Have a look here: http://clarks-garage.com/ - under 'garage shop manual' - starter motor, there's a couple of pics there which may help.

Miss Music

Original Poster:

28 posts

229 months

Sunday 18th September 2011
quotequote all
Thanks for that. Is the S2 wiring different? Do the three large cables run together?

Cheers.

Sandy59

2,733 posts

242 months

Sunday 18th September 2011
quotequote all
From a 968 drawing I've looked at - I think it's the same as an S2 - it appears 3 x black wires are connected together at the motor, with a smaller second red/black wire connected to another terminal, does that tie in ??

dazco

4,281 posts

220 months

Sunday 18th September 2011
quotequote all
Sandy59 said:
From a 968 drawing I've looked at - I think it's the same as an S2 - it appears 3 x black wires are connected together at the motor, with a smaller second red/black wire connected to another terminal, does that tie in ??
Wire them up before you put it in if you are unsure. The pinion will only fly out if the shaft turns the correct way. I reckon.